Your kitchen is coming along really well, and all that lovely light will be an absolute joy! Sadly, I have just a word of warning about the handles though. We had these in our kitchen, and they proved quite annoying. They’d catch on your clothing, especially blouses/shirts. That end of the front of button-through blouses, where the seam folds back would always get hooked onto the end of the handles! And pockets, too would get caught. This invariably ended up with torn clothing, as you continued to move away, not realising you’d been ‘caught’. We also live near the sea, and ours rusted over a few years, although that may be just an inferior brand. I lived with ours for about 4 years, then changed them all. We had them in our bathrooms, too, and they’ve all been changed as they were such a pain! I can see you love them, so don’t want to burst your bubble, but just thought I’d let you know. :(
Welcome to Willow Lane Cabinetry — the #1 place to buy affordable, semi-custom cabinets online! Let us help you create the kitchen of your dreams with our 100% free kitchen design tool. We offer all wood, semi-custom cabinets, fully assembled and delivered for free. Plus all the accessories you need to complete your remodel. Visit our website to see our products today!
2) I also note that it does not take long before doors start to sag & the gaps become irregular. Not hard to fix just lie on your back, take all doors off, then tighten everything & replace – then take a cold shower you will need it! It seems the cup sections remain well fixed but the fixing plates on the inside of the cupboard sides just work loose. This ought not to happen but it does & with all the concealed overlay hinges I have seen. Is there an answer? I suspect the hinges are under rated, 2 hinges for doors that typically are nearly 10Lbs may be the reason. Can you please comment.
The clean, industrial look of silver produces a calm ambiance, which pairs perfectly with your white cabinets. Silver is also bright enough, where it also stands out on your cabinets and gives your kitchen that shiny and sterile feel. The majority of today’s appliances are stainless steel, so your stainless steel hardware will share that uniform look.
In my opinion, going to a specialty showroom and paying the extra expense is worth it, because you’ll find choices outside the mainstream and you can get expert help there. These come from the selection at The Plumbery, a kitchen and bath fixture store in Northern California. Here you can see glass knobs, swirly knobs, modern knobs — all just a tad pricier than conventional choices at a hardware store. But look at the workmanship and style, even the heft. Though the average kitchen has 20 to 40 knobs, you might want to splurge for something unique.
Custom kitchen cabinetry doesn’t come cheap, but if you’re planning to stay put in your home for a long while, it’s worth spending to get exactly what you want, including the built-ins that enable you to live clutter-free. At the other end of the spectrum, we show you ways to modify Ikea kitchen components for a custom look (we’ve found almost a dozen new companies that offer doors to pair with Ikea’s cabinets).
I'm a wax girl. Wax always seems to work best for me and I'm ok with reapplying every 6 months or so. With that said, I cleaned them really good krud cutter. It's a great degreaser. Then sanded them first with 120 grit, then 180 grit, and finally 220 grit. Then cleaned them again with the vinegar/water mixture. I always have a spray bottle with the mix handy. Once dried, I primed and painted followed by waxing.
I can totally appreciate that. You’ll notice that these cabinets are also flush with the cabinet frames, which makes the hinges a little less noticeable. But sometimes, the hinge effect just isn’t quite as charming, and can be more distracting than anything. A lot depends on what kind of cabinet overlay you’re dealing with and the aesthetic that you’re looking for in this sort of project.
Prior to making the purchase of your new cabinet hardware, take some careful measurements of the existing hardware. Write down sizes, as well as the spacing of the screws. This should eliminate the need to drill new holes. Accurate measurements are essential to avoid additional work or the need to return and exchange your hardware purchase. In fact, it is a good idea to bring some of your old hardware with you for size comparison purposes, unless you are shopping online for your hardware. In that case, simply have the hardware next to you.
Budget: Get an idea of the full scope of your makeover project first. Then get an idea of how much of that budget can go toward your door and cabinetry hardware. The cost of individual pieces can be broad, as hardware can be produced by many methods. Material and intricacy of the handle itself affect price as well. A Gross Electric hardware expert will help you get the most bang for your buck.
Are your cabinets in good condition but old, worn out and dated looking (kind of like me!)? With just a few tweaks you can bring them into this century and get another 10 to 15 years of life out of them. It seems like back in the 70s and 80s kitchen cabinets were built on site and built to last! That’s the case with the kitchen I’m currently dealing with, the entire kitchen was site built, they made one long face frame for an 8’ bank of cabinets – picture all the face frames of your cabinets connected together and installed as one piece, that’s how this kitchen is. Anyway, I was happy with the layout, it’s pretty basic, so to save some money I decided to work with the existing cabinets by removing the valance, replacing the exposed hinges with concealed hinges and adding glass inserts to the upper, upper cabinets – you’ll see what I mean in a minute. If you have ever thought of updating your dated kitchen cabinets, you’ll definitely want to check out this article in all its splendor.
Do you dream of a whole-kitchen remodel straight out of a magazine photo spread? Kitchens begin to look dated more quickly than any other room in your home. Replacing cabinets and countertops is an expensive proposition, but what if you could update them just a bit at little cost? Replacing or adding new cabinet hardware is a great way to update your look with the latest finishes and styles, without breaking open the piggy bank.
The quick answer is yes, you can change the hinges. The hard part is what type. Cabinet doors have lots of different configurations.....full overlay, partial overlay, inset, etc., etc. The hinges have to fit the door style. There are hidden hinges that screw to the cabinet framework without major holes, and there are European type hinges that require a large hole to set the hinge into. Go to big box and look at the hinges, what is available can be mind boggling, until you understand the type of door you have.
Once you choose the style of hardware you want, it becomes easier to choose the right finish. There is a wide variety of cabinet hardware finishes: tarnished, polished, brushed, burnished, oil-rubbed, satin, antique or matte -- just to name a few. Stainless steel handles in a highly polished finish look great in a contemporary kitchen. Pewter and brass look more at home in a traditional setting. Bronze will patina over time, mature in appearance, and will make a bold statement in a kitchen. A black finish is dramatic on a light colored cabinet. Whatever you choose, just make sure the finish on your cabinet hardware complements the overall decor of your kitchen.
When I’m talking about metals, I consider the silver metals as one grouping. So, when you have stainless appliances (silver), a chrome faucet (silver) and brushed nickel lighting (silver) those all count as one metal in my book- SILVER. I personally think Nickel is the most timeless of the metals. Brass has really gained in popularity with interior designers, but is probably a trendier choice. I’ve seen a rise in the popularity of black hardware especially in this age of farmhouse- EVERYTHING (Thanks Chip and Joanna). I think every room in your house should have a little black in it, so if you can bring in the black with your second metal in your kitchen, DO IT!!