There are a couple of ways to go about choosing the right color and finish. One school of thought advises you to choose based on the color and finish of the kitchen’s faucet. Given that most faucets are either silver or brass in color, this advice can be limiting, especially if you have your eye on stone knobs or another finish that is not common in faucet design.


Are your cabinets in good condition but old, worn out and dated looking (kind of like me!)? With just a few tweaks you can bring them into this century and get another 10 to 15 years of life out of them. It seems like back in the 70s and 80s kitchen cabinets were built on site and built to last! That’s the case with the kitchen I’m currently dealing with, the entire kitchen was site built, they made one long face frame for an 8’ bank of cabinets – picture all the face frames of your cabinets connected together and installed as one piece, that’s how this kitchen is. Anyway, I was happy with the layout, it’s pretty basic, so to save some money I decided to work with the existing cabinets by removing the valance, replacing the exposed hinges with concealed hinges and adding glass inserts to the upper, upper cabinets – you’ll see what I mean in a minute. If you have ever thought of updating your dated kitchen cabinets, you’ll definitely want to check out this article in all its splendor.


Kitchen renovation is one of the important part of your kitchen. But for this first you should make a plan, after that decide the budget. There are variety of flooring materials and from this you should select one according to your needs and preferences. Then select the kitchen cabinet hardware. For this you should decide which design you want to select, then select the size and shape of the material. In your blog you give the clear idea on how to select the kitchen cabinet hardware. You can refer this: https://kitchenemp.net/kitchens/
If you’re going to paint or re-stain your cabinets now would be a good time to do that. I’m a painted wood kind of gal, so these cabinets got painted, plus it’s a lot quicker and easier to paint them than to sand and re-stain. After the doors and frames have been painted it’s time to install the hinges and the glass. Since my upper, upper cabinets will rarely get used I secured the glass with silicone, if your glass cabinets will get daily use then you might want to use silicone and glazing points. I also put removable frosted film on my glass because after we added puck lights to the upper, uppers I realized how ugly the inside of the cabinets looked.
As latches like these are elements that people come into contact with every day — literally gripping them for support or activating them with a gentle nudge — architects should keep both aesthetics and functionality in mind when specifying these seemingly simple components. To help you as you search for kitchen hardware on Source, here are a few savvy choices that fit well with modern clean spaces; ones that, even when situated in repetitive rows, won’t take attention away from sleek cabinetry design:
Sandra, I’m so glad that I came across your blog! You’ve given so much great information that I can use every day in my job doing kitchen cabinet sales. And then there’s the whole DIY part for me personally! I’m really hoping that you can answer my question, though. I have a customer who is refacing her cabinets. She has frameless cabinets and used to have exposed hinges. She wanted concealed hinges so we had the hinge holes drilled 1″ (center) from the edge. She has her new doors but when she hangs them, there’s a 1/4″ gap between the door and center stile, even after adjusting them. We were using full overlay hinges. Can you advise which type of overlay hinge to use and how to rectify the gap? Thanks so much!
“People come in and say they have a ‘standard’ door,” says Renee Genereux of the Brandino Brass team. “But there is no such thing as standard. You need to know your door thickness, how does it swing, what’s the width, what kind of holes do you have.” Avoid multiple visits to the hardware store because you don’t have all of the information and measurements you need. “We give them all of the questions to answer and then they come back with all of it.” Call Brandino Brass ahead of time to ask what you need to know for your visit or check out the sheet below as handy guideline for getting to know your doors and cabinets better.
“We find it refreshing for people to purchase what they like and what feels good to them, not caring what the ‘Joneses’ have,” says Renee. The Brandino Brass team regularly works with professionals who have their own signature styles. “One architect in town may use the same small knob all over the house all in the same finish for continuity. Another one will use different styles and finishes in each individual room,” says Jessie Isom, Brandino Brass team member. “There is no right or wrong if you like it.”
The quick answer is yes, you can change the hinges. The hard part is what type. Cabinet doors have lots of different configurations.....full overlay, partial overlay, inset, etc., etc. The hinges have to fit the door style. There are hidden hinges that screw to the cabinet framework without major holes, and there are European type hinges that require a large hole to set the hinge into. Go to big box and look at the hinges, what is available can be mind boggling, until you understand the type of door you have.

Shake a can of spray paint for the full amount of time recommended by the manufacturer. Position the can the recommended distance from the hinges and the screws to spray a light coat of paint. Use steady side-to-side sweeping strokes and maintain a consistent distance from the hinges to ensure a uniform coat of paint. Shake the can frequently while you spray, and spray the sides and edges. Allow the paint to dry for the amount of time recommended by the manufacturer. Apply a second coat of paint and allow it to dry completely.
Below and above the sink can be two different color schemes. Don’t worry, you can mix and match more than you might think and still obey the laws of symmetry. It can provide a sunny, uplifting splash to have a lighter color above the level of the countertops, such as a warm brass or gold. Particularly with items like faucets and sconces, a lighter color around eye level will create a happy glow.

But If you don’t think of your hardware as decorative (but as purely functional) and just want your pulls and knobs to blend into the background, instead of standing out, you can choose hardware that is more subtle.  Choose dark hardware for darker cabinets or silver or clear hardware for white or light cabinets.   Alternatively, you can forgo cabinet pulls and knobs all together, which will give a much more contemporary  look.

There’s no hard and fast rule on how long bar pulls should be, so go with personal preference. However, most designers keep them at two-thirds to three-quarters the width of the drawer. Notice they’re even longer in this kitchen, yet the length works. A good idea is to purchase a few knobs and pulls, bring them home and try them out before replacing your entire kitchen’s hardware.
Go to the home improvement center and get a 35mm Concealo Hinge mounting kit, it comes with a forstner bit (invented by Benjamin Forstner, in case you didn’t know) and a jig for marking the drill location. You’ll also want to make sure you get 35mm European-style hinges too, but before you buy them you’ll need to determine if you have ½” overlay or full overlay doors. ½” overlay doors overlap the face frames by a ½”, full overlay doors fully overlap the face frame leaving about an 1/8” showing on the outside edge. My doors were all ½” overlay, so I bought eighty 3-way adjustable hinges from eBay. I’m not sure what I was thinking because I ended up with a LOT of hinges left over. Warm up your drill and let’s move on to the next step.

Hardware makes an enormous difference in the bones of the cabinetry and the style of the room.  If I was facing down an oak kitchen that I wanted to live with, in harmony, for a bit of time, here’s what I would do in one weekend:  Paint it a great color.  Clear the counters.  Lay down a great, eye-catching rug.  Change out the hardware.  Add some color (probably a big framed print and a huge plant in a nice planter).  That’s it. 
Once you choose the style of hardware you want, it becomes easier to choose the right finish. There is a wide variety of cabinet hardware finishes: tarnished, polished, brushed, burnished, oil-rubbed, satin, antique or matte -- just to name a few. Stainless steel handles in a highly polished finish look great in a contemporary kitchen. Pewter and brass look more at home in a traditional setting. Bronze will patina over time, mature in appearance, and will make a bold statement in a kitchen. A black finish is dramatic on a light colored cabinet. Whatever you choose, just make sure the finish on your cabinet hardware complements the overall decor of your kitchen.
Go to the home improvement center and get a 35mm Concealo Hinge mounting kit, it comes with a forstner bit (invented by Benjamin Forstner, in case you didn’t know) and a jig for marking the drill location. You’ll also want to make sure you get 35mm European-style hinges too, but before you buy them you’ll need to determine if you have ½” overlay or full overlay doors. ½” overlay doors overlap the face frames by a ½”, full overlay doors fully overlap the face frame leaving about an 1/8” showing on the outside edge. My doors were all ½” overlay, so I bought eighty 3-way adjustable hinges from eBay. I’m not sure what I was thinking because I ended up with a LOT of hinges left over. Warm up your drill and let’s move on to the next step.

And starting to play with my new HVLP turbine spray system.  (Whenever I say HVLP turbine, I think of the movie “A Christmas Story” and how Ralphie describes his Red Ryder BB gun – “an official Red Ryder, carbine action, two-hundred shot range model air rifle.”  I think I’m equally enamored with my new gun, even if it doesn’t have a compass and a stock. 😉


The clean, industrial look of silver produces a calm ambiance, which pairs perfectly with your white cabinets. Silver is also bright enough, where it also stands out on your cabinets and gives your kitchen that shiny and sterile feel. The majority of today’s appliances are stainless steel, so your stainless steel hardware will share that uniform look.
If you’re looking for a more contemporary approach, tubular bars seem to be a favorite of the future. The current design couples beautifully with darker finishes and larger tiles. Tubular bars can also be used horizontally or vertically, and can be as long or short as you like. Go with a shorter bar for a more modest appeal, or make a statement with longer ones.
I would like to use a hinge similar to the wrap around no mortise Amaroc 3175s but am disappointed to learn the poor reviews ….sloppy….bent…flimsy…not worth it…low qc import. Perhaps they were better in the past! I would be most greatful if you could recommend a better quality hinge of that style. Alternatively,Can the full inset euro cup hinge be adapted to a face frame cabinet by building out the inside lip ^
This step will work best with raised panel or recessed panel cabinets, my cabinets are raised panel. OK, so I have a little confession to make, I outsourced this step, my routering skills are not top notch and I wanted the kitchen to look good, not like something put together by Dr. Frankenstein. The good news is it was very inexpensive and I was able to get 10 little doors done for less than the cost of a new upper cabinet. If you’re an ace with the router then you know exactly what to do, so have at it!

I watch you every Sunday morning. I used to help run a construction co. here in Knoxville,TN. I am now my Moms cargiver(87). I lost my dear sweet husband last November. I am trying to sale my house. I am just stressed trying to find replacement wrap-around hinges and pulls for my kitchen and bath. I also am going to replace my laminate tops. Do you have any sources I should check. You two remind me of my sweet dad and me from years ago. Please HELP!!!!!!
In line with our new content direction, Architizer is highlighting a different building-product and how to specify it. This week’s topic is Kitchen Cabinetry. If you’re looking for the perfect kitchen cabinetry for your next project, search for it on Architizer’s new network marketplace for building-products. Click here to see if you qualify. It’s free for architects.

With each pass of the roller and swipe of my paint brush I am making my way around the kitchen. Going back to standard time has slowed me down since it gets dark around 5 o’clock now. I like to paint in daylight, using electrical lights casts too many shadows and I miss spots. It is also getting colder outside. I was painting in the garage, but the temps have to be above 50 to paint, so I brought my painting set-up inside.

×