At Wayfair, we carry a wide selection of cabinet hardware so you can choose from many different options for your home. We carry the best cabinet hardware products, so you can find one that is just right for you. With our large selection of home goods, you're likely to find something that you'll love. If you're looking for where to buy cabinet hardware online, then you'll have no trouble finding a great option on Wayfair!
I'm a wax girl. Wax always seems to work best for me and I'm ok with reapplying every 6 months or so. With that said, I cleaned them really good krud cutter. It's a great degreaser. Then sanded them first with 120 grit, then 180 grit, and finally 220 grit. Then cleaned them again with the vinegar/water mixture. I always have a spray bottle with the mix handy. Once dried, I primed and painted followed by waxing.

What they are: Sturdy yet glamorous pulls that complement many styles of cabinetry. Here linear flat bar pulls not only underscore the contemporary feel of the kitchen, but oversize pulls eliminate the need for two pulls on a wide drawer. A good rule of thumb is to use two knobs or pulls on drawers 18 inches wide or wider. But if you choose superwide pulls like these, one is enough.
Finally, one of the more technical parts of cabinet hardware are the ball-bearing slides or tracks and latches that are used to open and close drawers and cabinets. Sliding tracks are what allow drawers to open and close smoothly, and using drawer slides that have soft-close ball bearings allow them to close slowly so that they don’t make much noise or rattle everything inside. Drawer slides are available in side-mount, center-mount, and undermount versions, depending on the amount of space you have between the drawer and the cabinet opening. 
The size of your cabinets will influence the size of your knobs. If your cabinets are smaller in scale you’ll want to opt for hardware that is likewise, such as minimal-scale circular knobs. Longer hardware is necessary when you have extra long cabinet doors—or can be used if you want to make a more of dramatic statement. Most cabinet doors are 24”, so you want a knob about 2”-3” size knob. For a larger cabinet door you can size up to 3½” or 4”. For a cabinet door under 20”, source hardware that’s closer to 1” to 2” size in diameter or length.
Painting cabinets yourself is cost-effective -- a few gallons of paint, sandpaper, cleaner -- but the process is time-intensive. You can paint most cabinet surfaces, but proper prep is key to success. For laminate and melamine finishes, be sure to rough up the surface with 150-grit sandpaper, and apply a good bonding primer before topping it off with the color of your choice.

Love the drawer pulls and glass knobs. I love the look of glass knobs too! I am so impressed that you spray painted the oven doors? They look great. As for that wooden valance over the sink – I would 86 that in a heartbeat! Nothing says out of date faster than that thing. Wondering if you could cut the ornate part off and maybe paper or paint with your pop color? What about under counter task lighting. I have halogen which are nice but also get very hot. I have seen others with flush mount hardwired fluorescent lighting which work just fine and a lot less expensive.


The size of your cabinets will influence the size of your knobs. If your cabinets are smaller in scale you’ll want to opt for hardware that is likewise, such as minimal-scale circular knobs. Longer hardware is necessary when you have extra long cabinet doors—or can be used if you want to make a more of dramatic statement. Most cabinet doors are 24”, so you want a knob about 2”-3” size knob. For a larger cabinet door you can size up to 3½” or 4”. For a cabinet door under 20”, source hardware that’s closer to 1” to 2” size in diameter or length.
Mona Culberson began working on the assembly line at a large manufacturing company in 1983, where she worked her way up into several positions of business responsibility. In 2005, she began a career in roofing, interior design and remodeling. She works daily as a professional painter/home remodeler/handywoman while lending her husband's roofing business a helping hand in her spare time.

When decorating your rustic kitchen, a little bit of detail can go along way! There are many round, cast iron options that have designs that look great in rustic kitchens. If cast iron is too dark for your cabinets, look for an antique pewter finish. The detail within the hardware itself will certainly add to the look. This option also works well for a farmhouse style kitchen, giving it a great country feel.

In line with our new content direction, Architizer is highlighting a different building-product and how to specify it. This week’s topic is Kitchen Cabinetry. If you’re looking for the perfect kitchen cabinetry for your next project, search for it on Architizer’s new network marketplace for building-products. Click here to see if you qualify. It’s free for architects.
For this step you’ll want to clamp your door to the work surface, unless of course you want your door to spin around in circles and possibly punch you in the stomach. Next, measure equal distance from the top and bottom of the door and mark the center hole with the jig, also mark the 2 side holes where you’ll screw the hinge in place (I found that using an awl to mark the holes made it easier to drill). We drilled for our hinges over the same location as the old ones, which were NOT equal distance from the top and bottom, but at least every door was at the same unequal distance.
In contrast to knobs, which have only one screw attachment, a cabinet pull (or cabinet handle) is attached to the cabinet door or drawer front with two or more screws. Because there are multiple screw holes, one of the most determinative factors in choosing handles is the center-to-center measurement; i.e., the difference from the center of one screw hole to the center of the next.  
One popular subset of modern drawer cabinet pulls are cup pulls, sometimes also known as half-moon pulls because of their half-circle form. Rather than wrap your fingers around a bar, as is the case with most pulls, users slip their fingers in the underside of a cup handle, pulling towards themselves. A similar but even more modern version of this is the finger pull, where a U-shaped pull gets installed to the inside edge of a drawer, leaving an L-shaped pull that your fingers slide under. These two types of modern cabinet pulls are installed using a specific mounting method, and they can only be installed in one direction, facing down.
Aside from polishing, the look of stone hardware is largely in the hands of nature. Though your hardware pieces may all share traits if they come from the same slab of rock, each piece is going to be different. This creates a natural variety in appearance that will add zest to your room. Stone is cool to the touch and looks especially lovely in homes with a woodsy touch.
Now comes the fun part, place the point of the forstner bit in the center hole you marked earlier and start drilling, drill the holes ½” deep, that’s the thickness of the bit. The instructions on the back of the kit say “do not drill completely through the door,” Ummm, OK… You’ll want to do this twice on every door, 36” or 42” doors may need 3 hinges each. Let’s backtrack a little here, when you remove the doors mark them and the cabinet box so you’ll know where they go back. Now, do that over and over and over again until all your doors are finished.
Dreamer, thinker, + lemon squeezer; you'll usually find me clutching a mug of coffee, glue gun, fandeck of paint colors, and a child at any given time. This mom of two (and wife to one) loves to share freshly squeezed ideas for home and family. Join the adventure as we learn most lemons can indeed become lemonade-- with generous amounts of sweetness, perspective, and love.
Dreamer, thinker, + lemon squeezer; you'll usually find me clutching a mug of coffee, glue gun, fandeck of paint colors, and a child at any given time. This mom of two (and wife to one) loves to share freshly squeezed ideas for home and family. Join the adventure as we learn most lemons can indeed become lemonade-- with generous amounts of sweetness, perspective, and love.
The quick answer is yes, you can change the hinges. The hard part is what type. Cabinet doors have lots of different configurations.....full overlay, partial overlay, inset, etc., etc. The hinges have to fit the door style. There are hidden hinges that screw to the cabinet framework without major holes, and there are European type hinges that require a large hole to set the hinge into. Go to big box and look at the hinges, what is available can be mind boggling, until you understand the type of door you have.
But If you don’t think of your hardware as decorative (but as purely functional) and just want your pulls and knobs to blend into the background, instead of standing out, you can choose hardware that is more subtle.  Choose dark hardware for darker cabinets or silver or clear hardware for white or light cabinets.   Alternatively, you can forgo cabinet pulls and knobs all together, which will give a much more contemporary  look.
Knobs, which are attached with a single screw, are most frequently used on cabinets, and are available with a built-in screw, known as a one-piece knob, or with a separate top and fastener, known as a two-piece design. Modern drawer knobs are made in a variety of materials including brass, zinc, stainless steel (sometimes found in kitchens), bronze, glass, crystal, plastic, wood, and other natural and man-made materials. 

Accessorizing is the most important part of any outfit. A little glimmer, a little glam or maybe something unexpected and modern can make an ensemble. Well, I think that accessorizing happens to be just as important when decorating your home, which is why we’re exploring the “jewelry options” for the kitchen: hardware! Often overlooked, but capable of extreme 'wow' factor, the pulls on our cupboards can easily be swapped out to drastically change the style of your space.
×