I love your site and your super helpful advice. We’re installing full overlay cabinets in our kitchen and we’re trying to select hinges for the upper cabinets — particularly the cupboard doors on the end which when closed is perpendicular to a wall. Since the door aren’t inset, I’m concerned we won’t be able to open the cupboard a full 90 degrees. Basically, the issue is how to solve the problem of the door swing? Are there any hinges that could solve this problem? I can send elevations if that helps. Thanks so much in advance!

Thanks, Marty! You have a joyous looking kitchen/dining room – so beautiful! LOVE it! Not at all stiff and cookie-cutter, but with real individual style! An inspiration today. Your timing is perfect. We have our IKEA kitchen done, except for countertops and backsplash tiling. (We’ve been using Masonite board for a makeshift countertop. Not too bad.) The whole look of our open kitchen/dining room is pleasant, at this point, but bland. Pale minty-grass green walls, blonde (birch) cabinets, warm medium oak floors. Now for putting in some details! YAY! The scary part: Now what? Yikes!! Marty to the rescue with a reassuring article. THANKS! Here we go……
Custom kitchen cabinetry doesn’t come cheap, but if you’re planning to stay put in your home for a long while, it’s worth spending to get exactly what you want, including the built-ins that enable you to live clutter-free. At the other end of the spectrum, we show you ways to modify Ikea kitchen components for a custom look (we’ve found almost a dozen new companies that offer doors to pair with Ikea’s cabinets).
Are your cabinets in good condition but old, worn out and dated looking (kind of like me!)? With just a few tweaks you can bring them into this century and get another 10 to 15 years of life out of them. It seems like back in the 70s and 80s kitchen cabinets were built on site and built to last! That’s the case with the kitchen I’m currently dealing with, the entire kitchen was site built, they made one long face frame for an 8’ bank of cabinets – picture all the face frames of your cabinets connected together and installed as one piece, that’s how this kitchen is. Anyway, I was happy with the layout, it’s pretty basic, so to save some money I decided to work with the existing cabinets by removing the valance, replacing the exposed hinges with concealed hinges and adding glass inserts to the upper, upper cabinets – you’ll see what I mean in a minute. If you have ever thought of updating your dated kitchen cabinets, you’ll definitely want to check out this article in all its splendor.
At this point, you will have narrowed down your hardware choices to a specific style, type, size and finish. Next thing to incorporate is your budget. A good starting point is to count how many knobs and pulls you will need for your cabinetry and determine a price range that is comfortable for you. Many hardware manufacturers have multiple lines of varying quality and price, so be sure to find a manufacturer that uses high-quality materials. Buying cheap can seem like a good idea in the short run, but cheaper metals will degrade faster down the road and face a much higher risk of breaking or bending. Stainless steel hardware, for example, should be solid (not hollow) with a durable but even finish.
Welcome to Willow Lane Cabinetry — the #1 place to buy affordable, semi-custom cabinets online! Let us help you create the kitchen of your dreams with our 100% free kitchen design tool. We offer all wood, semi-custom cabinets, fully assembled and delivered for free. Plus all the accessories you need to complete your remodel. Visit our website to see our products today!
Some styles of kitchen cabinets are designed to open at the side of the door, so they don’t have outer knobs. When re-facing cupboard doors as part of a remodeling project, new knobs can still be added to these self-opening styles. Consider adding knobs or handles that create visual interest. Careful planning is needed as holes will need to be drilled in the cabinet doors to add the new knobs.
Furthermore, hardware attracts the eye like a bright light. Functionality aside, it is the ultimate accent piece — it provides a pop to cabinets and drawers that can make or break the décor of a room. It also keeps the wood of our cabinets and drawers looking fresh by taking the brunt of the natural oils in our hands, which we leave behind every time we reach for the cabinet to grab something.
But If you don’t think of your hardware as decorative (but as purely functional) and just want your pulls and knobs to blend into the background, instead of standing out, you can choose hardware that is more subtle.  Choose dark hardware for darker cabinets or silver or clear hardware for white or light cabinets.   Alternatively, you can forgo cabinet pulls and knobs all together, which will give a much more contemporary  look.
What they are: Art objects as much as pulls, these knobs draw attention. Placed in the center, they draw your eye to the detailing of the worn wood here. Search salvage yards for antique ones and don’t be afraid to spring for the few knobs you’ll need. If you can’t find this sort of door detailing, you can create a similar effect by placing a medallion behind each knob in the center of your doors. Look for antitwist pins to keep the knob from spinning (in fact, do this with any round knob).
Cup pulls are a nice complement to Shaker-style cabinets, particularly in a country-style kitchen. Recessed hardware can make for a particularly elegant and modern look, but also tends to be a bit on the pricey side. Slim, modern finger pull type hardware, which mounts to the top of a drawer or the edge of a cabinet, is a nice choice for flat-front cabinets in a modern kitchen.
“What is your overall style? Traditional, contemporary, arts and crafts, eclectic, cottage, French, Mediterranean, Western, Art Deco or coastal,” asks Brandino Brass co-owner Eric Brandino. He encourages clients to think about the style of their home or the style they would like to incorporate. “Is there a consistent style throughout or does it vary from room to room? Transitional style has been one of the most popular looks recently,” he says of what’s trending in hardware. “Clean lines with just a touch of traditional features and finishes, such as an unlacquered brass or bronze.”
I have the exact hinge you mentioned under the caption “Then there are Overlay Hinges where you can see part of the hinge as well.” My problem is that on the 3 sets of doors we have that have no center stile, the doors are pushed too far toward center, therefore not enough space to close properly. Any suggestions other than taking down the doors and planing them? Hate that option on already completely finished doors. Great informative post.
You might think that after making dozens of tough decisions during your kitchen remodel, something like choosing handles for your cabinets would be easy. Yeah, so not the case. You’ll soon find out that there are more cabinet knob options than there are stars in the sky. But don’t panic. And by all means, don’t make a knee-jerk decision just to get it over with. When I used to make up design and swatch boards, I would remind clients that the hardware matters as much as the big stuff. Remember, you’ll be looking at and touching your kitchen cabinet knobs every single day. So you want to make the right choice. And after all, this is a micro design element that can have macro impact.
It’s definitely possible to change out the hinges without redoing the cabinets – you would just have to make sure that the holes on the frames where the old hinges were, are able to be filled and touched up so that they’re not obvious. I’m not sure of the cost, but hinges aren’t cheap, and I definitely recommend using a carpenter to do the work. Hinges can be maddening!
If your old fridge still runs like a champ on the inside but it’s starting to look like a but run-down and haggard on the outside, spruce it up with a DIY custom cover! Appliance covers are fastened directly to the outside of your appliance, masking their appearance on the outside and making them blend in with your kitchen cabinetry. You can take materials like bead board paneling, wallpaper, wood from old pallets or even mismatched wood scraps from barns to create an interesting look for your old appliance.
Updating the hardware on your kitchen windows can take them from standard to standout in seconds! Typically, window sash locks and lift pulls blend in with your window color, but switching these traditional styles up with an elegant bronze or a satin nickel finish will add interest and pizzazz to your windows. You can also choose a finish that matches the rest of your kitchen hardware for a pulled together style.

For knobs on a cabinet with a stile, like Shaker-style cabinets, allow the stile to be a guide for hanging the knob. If the knob is too large to comfortably fit in the corner where the two stiles meet, then hang the knob centered on the vertical stile, with the bottom edge of the knob aligned with the top of the intersecting horizontal stile. (Or the top of the knob aligned with the bottom of the stile, for lower cabinets). The knobs in this kitchen from Ivory Lane are a good example.

That being said, buying every make and model turned out to be a good idea. I was pretty pumped when I installed my first door…until I shut the door and there was a gap the size of Kansas where the door didn’t cover my opening. I should have taken a picture because it was pretty hilarious-looking. Wrong hinge. So I removed the 1 1/4″ overlay hinge, installed the 1/2″ overlay and was good to go. The holes that need to be drilled in the door will be the same in size, depth and location regardless of your overlay measurement.
Hidden hinges also come in a soft-close style if you’re one of those people who want the latest and greatest. (Is it really that bad to hear a door close?) My new cabinets came with soft close hinges that I personally could take or leave.  I still find myself trying to shut them all the way instead of letting them do their thing. You might not want soft-close hinges if you’re the type who likes to slam things when irritated. (Just a thought.)

With each pass of the roller and swipe of my paint brush I am making my way around the kitchen. Going back to standard time has slowed me down since it gets dark around 5 o’clock now. I like to paint in daylight, using electrical lights casts too many shadows and I miss spots. It is also getting colder outside. I was painting in the garage, but the temps have to be above 50 to paint, so I brought my painting set-up inside.
×