I have the exact hinge you mentioned under the caption “Then there are Overlay Hinges where you can see part of the hinge as well.” My problem is that on the 3 sets of doors we have that have no center stile, the doors are pushed too far toward center, therefore not enough space to close properly. Any suggestions other than taking down the doors and planing them? Hate that option on already completely finished doors. Great informative post.

Now comes the fun part, place the point of the forstner bit in the center hole you marked earlier and start drilling, drill the holes ½” deep, that’s the thickness of the bit. The instructions on the back of the kit say “do not drill completely through the door,” Ummm, OK… You’ll want to do this twice on every door, 36” or 42” doors may need 3 hinges each. Let’s backtrack a little here, when you remove the doors mark them and the cabinet box so you’ll know where they go back. Now, do that over and over and over again until all your doors are finished.
Standard hardware is a breeze to install. All you need is a Phillips-Head screwdriver. Simply replace standard screws into the pre-cut holes.If the holes are pre-drilled on your cabinet drawers and you now want to place a single hole, measure the distance between the two holes and center. If your cabinet doesn’t currently have holes or hardware, knowing where to place the different size knobs on each cabinet can be tricky. If there are no holes, and you’re on your own when drilling into the corner of the cabinet door give yourself 2 1/2 to 3″ of space in the corner before you drill in a hole.
For pulls on a flat front cabinet, the bottom corner of the pull should be equidistant from both sides of the cabinet. For Shaker-style cabinets, the same rules apply as with knobs: center the pull on the vertical stile, with the bottom of the pull even with the top of the horizontal stile (or the top even with the bottom of the horizontal stile, for a lower cabinet). These aren’t hard and fast rules—you may want to adjust them depending on what looks best for your cabinets and hardware—but they’re a good place to start.
Some pulls and handles are specifically made for appliances like refrigerators, dishwashers, and other appliances where you might have panels installed on the front of the item to match the surrounding cabinetry. Typically, appliance handles and pulls have been designed to higher standards than traditional, mid-century, or modern cabinet drawer pulls because they need to withstand more wear and tear—your fridge door has suction that resists opening, and you probably open the fridge more times than most of the cabinets in your kitchen. As a result, many appliance handles and pulls are larger, wider, or thicker than similar cabinet hardware.

Accessorizing is the most important part of any outfit. A little glimmer, a little glam or maybe something unexpected and modern can make an ensemble. Well, I think that accessorizing happens to be just as important when decorating your home, which is why we’re exploring the “jewelry options” for the kitchen: hardware! Often overlooked, but capable of extreme 'wow' factor, the pulls on our cupboards can easily be swapped out to drastically change the style of your space.
×