In contrast to knobs, which have only one screw attachment, a cabinet pull (or cabinet handle) is attached to the cabinet door or drawer front with two or more screws. Because there are multiple screw holes, one of the most determinative factors in choosing handles is the center-to-center measurement; i.e., the difference from the center of one screw hole to the center of the next.  
Standard hardware is a breeze to install. All you need is a Phillips-Head screwdriver. Simply replace standard screws into the pre-cut holes.If the holes are pre-drilled on your cabinet drawers and you now want to place a single hole, measure the distance between the two holes and center. If your cabinet doesn’t currently have holes or hardware, knowing where to place the different size knobs on each cabinet can be tricky. If there are no holes, and you’re on your own when drilling into the corner of the cabinet door give yourself 2 1/2 to 3″ of space in the corner before you drill in a hole.
The homeowner has already installed a new tile backsplash, and will also be replacing the floors with new tile and painting the walls once I’m finished with the cabinets.  But the homeowner was concerned about the hinges standing out against a light cabinet color.  A cabinet refresh is going to help tie the updates together, and when we got to talking about the hinges, I did some research, and found a great local woodworker to help change the hinges from exposed to concealed.
I have the exact hinge you mentioned under the caption “Then there are Overlay Hinges where you can see part of the hinge as well.” My problem is that on the 3 sets of doors we have that have no center stile, the doors are pushed too far toward center, therefore not enough space to close properly. Any suggestions other than taking down the doors and planing them? Hate that option on already completely finished doors. Great informative post.

I have the exact hinge you mentioned under the caption “Then there are Overlay Hinges where you can see part of the hinge as well.” My problem is that on the 3 sets of doors we have that have no center stile, the doors are pushed too far toward center, therefore not enough space to close properly. Any suggestions other than taking down the doors and planing them? Hate that option on already completely finished doors. Great informative post.


I’m currently on the hunt for the perfect brass pulls to update my run-of-the-mill silver knobs. But to get a whole sense of what's available at the hardware store these days, I'm looking beyond just brass and test-driving a few other options as well. From handsome black bars to boho porcelain and even DIY leather, these gorgeous hardware options are sure to inspire.
×