• Lack of harmony — building a shed that does not match the design or the color of your house would make the compound look a bit odd. It is advisable that you choose a suitable architectural design and color that will closely match with your house. That gives your compound a great look and also makes it look like both structures were built at the same time. It also gives you a sense of satisfaction and hence you will not have to waste money in the future to make one structure resemble the other.
If you plan to paint your shed, natural wood siding isn’t necessary. You can buy sheets of OSB (oriented strand board) siding at a fraction of the cost of real plywood, and it’ll probably last longer too. LP SmartSide panel is one brand. You can buy plain, grooved or stucco-like panels in several thicknesses and sizes. Ask at your local lumberyard to see what’s available.
Each truss is made up of two 2 x 4 rafters and one 2 x 4 ceiling joist. The three boards are joined together with 1/2-in. plywood gussets. To speed up the assembly process, build all the trusses on the shed floor before erecting the walls. Start by cutting all the rafters to length with a 40° angle at one end of each. Cut 2 x 4s to 10 ft. long for the bottom chords of the trusses. Also, cut all of the plywood gussets.
There are several ways to economize when building a shed: Install three-tab roof shingles instead of architectural shingles, or use grooved-plywood siding in place of cedar bevel siding. But don't ever skimp on the building materials used for the floor frame or plywood floor deck. I can't tell you how often I've walked into a shed and found the floor to be dangerously spongy. One building in particular had a floor so badly rotted it felt like one of those inflatable moonwalk attractions you see at carnivals.
As you can see, I have no pictures of the doors being created.  This is because they took way too much trouble to make, and I didn't really have the patience to take pictures of them being built because they were tested and redone about 3 times.  Lesson to be learned:  leave the tolerances bigger than you think they will need to be, you can always use weather strips to help close them up later.  After 3 attempts, we finnally got the doors to work properly.  The one door is held in place with sliding dead-bolts to the floor and ceiling frames and the second door is attached to it with another dead-bolt.
In a Vero Beach, Florida, midcentury modern neighborhood, Sanders Pace Architecture retained the lines and essence of the original house while redesigning it for their client's 21st-century lifestyle. Although it's at the front of the house and initially might resemble a garage, the detached "shed" can be used as a private studio or for guests. Because it's located on the coast, hurricane-proof doors were needed, but cedar was installed over them for an attractive but sturdy structure.
Building something yourself, especially something as big as a shed, is always rewarding, but not only will it feel good to have a self-made beauty in your backyard, it’s times lower in cost than buying a shed. In fact, building a small shed can cost as little as $100! That’s a pennysaver! And well, all proper DIY wood projects should be, ain’t that right?
When you start to look at the plans, you realize some are absurdly out of date, or impossible to read because they are blurred - just like everyone else has reported on this site. What was even more appalling was it appeared most, if not all of what I had purchased, was easily available for free online. Some material looked as though it may have been pilfered - or "borrowed without permission or attribution from educational sites. And much of the "VIP-Premium" content was past its copyright - which is great if you want a children's woodworking book from the 1800's for historical purposes, which I'm sure is a fascinating read, but all that was ultimately meaningless since the sum total of what I downloaded offered nothing of any immediate benefit toward building a shed from a quality, step-by-step plan, with 3-D renderings, Material lists, and best practices, etc to help you build quickly, efficiently, and have something you can use and be proud of. I think the only proprietary plans must the the freebie they give away to entice you to pony up.
Pasadena, California, is known for its Craftsman style homes, a great number of which have been carefully preserved and restored. Owned by a University of Southern California (USC)-educated architect, Nott & Associates specializes in the Craftsman style. For a backyard shed, Nott custom designed and constructed the wooden doors, which include period-perfect details and hardware.
The DIY shed plans come in various sizes and shapes, few of them even with a little porch. They have a beautiful natural appearance to fit perfectly into your garden or backyard. As are the advantages of all types of small house plans, our outdoor sheds are also designed to be simple, durable, low-cost and to work effectively with a space. If you are creative mind yourself, our plans can serve as a sole inspiration for your own garden sheds designs.
Pasadena, California, is known for its Craftsman style homes, a great number of which have been carefully preserved and restored. Owned by a University of Southern California (USC)-educated architect, Nott & Associates specializes in the Craftsman style. For a backyard shed, Nott custom designed and constructed the wooden doors, which include period-perfect details and hardware.
You can build the walls on any flat surface, but the shed platform is ideal. Snap chalk lines on the plywood deck, 3-1/2 in. from the edges of the platform, to indicate the inside edge of the walls. Measure to make sure the lines are parallel and 89 in. apart. Then chalk a line down the center (Photo 1). You’ll use this line to make sure the angled top plates meet in the center.
For those who don’t quite believe in My Shed Plans, they offer a 60 day trial. If within those 60 days, you feel like the product hasn’t lived up to its hype, you may return it and receive a full refund. A decent outdoor shed can be built in a week or two depending on your schedule, and the amount of time you have to build it. Therefore, 60 days is enough for you to test out the product and see what you come up with. If you have a shed worthy of showing off to your buddies, or gal pals, then keep it. If you have a heap of materials in a pile that resembles something Homer Simpson might have created, then return it. No big deal.
Then, you will need to install a series of floor joists across the entire length of the support beams; these will need to be the same length as the distance between the two rim joints so that they’ll fit between them. In the example design, the floor joists are all separated by 14.5-inch gaps except for the outermost two, which are 13 3⁄4 inches (34.9 cm) from their immediate neighbors; this is to allow a standard piece of plywood to line up with the outermost edge of the outermost joist but only cover half of an interior joist, allowing its neighbor to cover the other half so that both can be supported properly.[3]
My Shed Plans by Ryan Henderson is a comprehensive collection of over 12,000 easy to follow, step-by-step Shed and Woodworking Plans. Plus, you are getting an additional 400 Woodworking Plans. What I don’t like about My Shed Plans is I will never ever build a fraction of these Amazing Shed Plans. There is just too many Shed Plans for a weekend warrior like myself.
Also square the frame by making sure diagonal measurements from opposite corners are equal. Then tack one corner to hold it square. Finally, nail the soffit to the roof frame with 6d galvanized box nails. We used 12-in.-wide fiber cement siding for soffit material. Mount an inexpensive carbide blade on your circular saw to cut the fiber cement. Set the roof panel aside and build the other half of the roof using the same techniques.
For those who don’t quite believe in My Shed Plans, they offer a 60 day trial. If within those 60 days, you feel like the product hasn’t lived up to its hype, you may return it and receive a full refund. A decent outdoor shed can be built in a week or two depending on your schedule, and the amount of time you have to build it. Therefore, 60 days is enough for you to test out the product and see what you come up with. If you have a shed worthy of showing off to your buddies, or gal pals, then keep it. If you have a heap of materials in a pile that resembles something Homer Simpson might have created, then return it. No big deal.

Build the framework for the side walls. The bottom plate of each side wall should be the same length as the distance between the bottom plates of the front and back wall (so that the side walls will fit between them). The standard spacing between vertical wall studs in the US is 16 inches (from center to center, not from edge to edge); since this stud spacing doesn’t perfectly divide into the total length of the side walls in the example design, the two outermost studs make up for this discrepancy by being slightly closer to their neighbors. Most importantly, the top plate is angled so that the roof will be sloped, which makes the height of each vertical stud slightly different. If you’re not sure how to calculate the necessary height of each vertical stud in advance, make the two outermost vertical studs first, lay them the correct distance apart, cut a top plate that spans this distance, and then cut each remaining vertical stud individually based on the distance between the top and bottom plates at that exact location.[8]


They are the simplest and cheapest sheds one may find. They are easily assembled by regular people, they do not require initial construction knowledge. One may find the DIY kits and plans for these type of sheds. The most common type of sheds is plastic and wooden. They are mainly used to store garden tools, tractors and store items that are considered unsafe to be stored indoors such as gasoline and agricultural chemicals.
Start by setting deck blocks on the ground, positioned as shown in the plans. While the area doesn’t have to be perfectly level, you should make the ground roughly level where each block will rest. Temporarily place some straight 2-by-6 lumber on edge in the top grooves of the blocks to orient the blocks in a straight line. Arrange two rows of four blocks parallel to each other to form both long walls, then measure diagonally across the outside corners to determine how square the arrangement is. If the two long walls are parallel, and diagonal measurements taken across corners are equal, then each corner is guaranteed to be 90 degrees. Finish up by placing one deck block in the middle of each 6-foot wall after you have aligned and squared the 8-foot walls.

This is nothing but a pyramid scheme in disguise. Don't spend the first $37.00, they lead you to believe that you are getting discs and actual plans until you pay $37.00, then they tell you that you have to download everything but at an additional price. I'm calling the Fraud Department at the Texas State Attorney Generals office and reporting them.
· Gambrel styled shed — it is a very common type of shed. Its roof is highly steep and is four sided. This type of shed at some point resembles a hexagon. This type of shed is preferred as the shape of its roof makes the interior of the shed to be spacious hence creating more space where a lot of garden and outdoor tools can be stored. In this type of shed, one may have a workshop in the shed. They can even accommodate a car due to their large spaces.
×