Then, you will need to install a series of floor joists across the entire length of the support beams; these will need to be the same length as the distance between the two rim joints so that they’ll fit between them. In the example design, the floor joists are all separated by 14.5-inch gaps except for the outermost two, which are 13 3⁄4 inches (34.9 cm) from their immediate neighbors; this is to allow a standard piece of plywood to line up with the outermost edge of the outermost joist but only cover half of an interior joist, allowing its neighbor to cover the other half so that both can be supported properly.
Cut the treated 6x6s to 12 ft. and set them on the gravel so they’re parallel and the outside edges are 6 ft. apart. On sloped ground, you’ll have to raise the 6×6 on the low side until it’s level with the adjacent 6×6. Do this by stacking treated 2x6s, 4x6s or 6x6s on top of the treated 6×6 to reach the right height. Use a 4-ft. or longer level to make sure the 6x6s are level and level with each other. Finally, square the 6x6s by adjusting the position of one 6×6. Slide the 6×6 back and forth, not sideways, until the diagonal measurements from opposite corners are equal. Build the platform with treated 2x6s, 24 in. on center, and cover it with treated 3/4-in. plywood (Figure B).
Building something yourself, especially something as big as a shed, is always rewarding, but not only will it feel good to have a self-made beauty in your backyard, it’s times lower in cost than buying a shed. In fact, building a small shed can cost as little as $100! That’s a pennysaver! And well, all proper DIY wood projects should be, ain’t that right?
• Stagnant waters — As much as the wood is coated to protect it from water, it would still be advisable to keep the wood away from stagnant waters. This is as the wood coating is not a permanent coat and so is the wood is exposed to water it will get damaged over time. The best way to avoid water paddles near the shed is building gutter systems on its roof which directs the water to a tank or a pool.
The program consists of a wide range of downloadable files, which contain many different step by step instructions and plans related to woodworking. These tutorials are focused on a wide range of projects, such as potting shed plans, wood shed plans, storage shed plans, garage storage plans, house plans and more. All the shed plans discussed in this program are divided on the basis of each project type.