The framing is the most important part of the above-ground structure because it stiffens up the plywood boards and supports the roof. You will need a lot of 2x4's, and a way to attach them. We used this as an excuse to buy some new air hammers from canadian tire. We were able to get the lumber for the entire project delivered by a company called Tamrack Lumber. They brought out a truck and dropped off all the supplies. For the roofing you will need little plates with groups of nails sticking out of them which I believe are called joist plates. These are used on the angles to keep them from shifting. The last thing you will need is a way to cut all of the 2x4's. To do this we borrowed a very nice miter saw from a friend for a few days. It is much easier if the cutting tool can cut on angles, otherwise you will be left to improvise when cutting the peices for the roof.
This is nothing but a pyramid scheme in disguise. Don't spend the first $37.00, they lead you to believe that you are getting discs and actual plans until you pay $37.00, then they tell you that you have to download everything but at an additional price. I'm calling the Fraud Department at the Texas State Attorney Generals office and reporting them.
Now that the skeleton of your roof is ready, it’s to go pro. You will be adding roof felt and shingles to make your roof robust, resilient and obviously good looking. Metal roof sheets, fiberglass and felt are some of the basic options you have. Feel free to use any material you like for the roofing. However, we recommend using felt since it is easier to work with and install, and is highly weather and water resistant.
• Lack of harmony — building a shed that does not match the design or the color of your house would make the compound look a bit odd. It is advisable that you choose a suitable architectural design and color that will closely match with your house. That gives your compound a great look and also makes it look like both structures were built at the same time. It also gives you a sense of satisfaction and hence you will not have to waste money in the future to make one structure resemble the other.
• The ceiling is too low — these may tend to be one of the least concentrated on problems as they happen least when one expects. It is important to be aware of the low ceiling so as to save on your funds in putting a higher one. Ensure that each and every measurement is taken carefully and is also executed. The best way to determine the height of your shed is by scanning through the items you are planning to store there and use the tallest. As mentioned earlier, the installation of steep roofs might be risky but in the long run become an added advantage as they create more space inside the shed.
Whether you build your own trusses or order them from the lumberyard, building a roof with trusses is much easier than framing a roof one rafter at a time. As a general rule when learning how to build a shed roof, you’ll need one truss every 2 ft. If you build your own, the cost will be about half this amount. Connect the framing for site-built trusses with plywood gussets glued and screwed to the joints.
Build the framework for all four walls. To account for the fact that the front and back walls are different from each other (due to the doorframe in the front) and the side walls must both be sloped (to prevent rain from collecting on the roof), each of these will have to be tackled somewhat differently. It’s easiest to construct the back first, the front second, and the two sides last, as shown in the numbered image below. See How to Frame a Wall for more information before you read the instructions below.