Structurally speaking, some sheds are actually miniature versions of houses or barns. The gambrel storage shed plans from mybackyardplans explain the basic steps of such a project. First, the foundation is built. Then the sidewalls are installed, after that comes the roof frame, the front wall and the door, then the back wall and roof decking, the trim and finally the shingles. At the very end, the shed is painted.

Each truss is made up of two 2 x 4 rafters and one 2 x 4 ceiling joist. The three boards are joined together with 1/2-in. plywood gussets. To speed up the assembly process, build all the trusses on the shed floor before erecting the walls. Start by cutting all the rafters to length with a 40° angle at one end of each. Cut 2 x 4s to 10 ft. long for the bottom chords of the trusses. Also, cut all of the plywood gussets.


Our 14 by 24 one car garage was delivered and set up early November. The truck pulled up shortly before 7 am and left by 5 pm after the garage was completed and cleaned inside and out. Two carpenters worked tiredlessly without even a lunchbreak to make sure that everything was complete by the evening. Despite the workpressure the always had a kind word and did not mind to answer our stupid questions. We haven't seen such a work ethics for quite some time. On top of it, the garage looks terrific and matches the style of the house. When asked I will recommend Sheds Unlimited without any reservation - a job very well done!
In a Vero Beach, Florida, midcentury modern neighborhood, Sanders Pace Architecture retained the lines and essence of the original house while redesigning it for their client's 21st-century lifestyle. Although it's at the front of the house and initially might resemble a garage, the detached "shed" can be used as a private studio or for guests. Because it's located on the coast, hurricane-proof doors were needed, but cedar was installed over them for an attractive but sturdy structure.
It’s not always possible, but if you’re using 4 x 8-ft. sheet siding and have enough helpers around to lift the wall when you’re done, you can save time by siding the walls before you raise them. Make sure to straighten the wall plates and square the wall by measuring diagonally before you nail on the siding. This is easier to do on a wood shed floor because you can tack the plates to the floor to hold the wall straight and square while you install the siding.
This shed featured on houzz is inspiring in many different ways. First, check out the design. Isn’t it charming how all the different types of wood and all the different colors complement each other? What a wonderful way to use reclaimed wood pieces…Another detail that has to do with the design is the fact that this shed has clerestory windows. It’s not usually common for shed to have windows of any kind but, when you think about, it’s a pretty practical feature.

Normally we try to help our customers as much as possible, especially if it is a matter of helping to figure out where certain material goes on the building. Keep in mind, you are responsible for correctly constructing the shed if you purchase a kit, but we can offer direction. (Prior construction experience is recommended.) If there is any uncertainty about whether or not you will be able to assemble the storage shed, consider one of our build-on-site options and we will send a team to assemble the building for you.
I felt that this is a very poorly setup web site. I purchased the Ryan’s shed plans online, did not receive an emailed receipt or link to the web site that worked. Phoned Clikbank and they promised to send another receipt. They did not. I had saved the original online confirmation with the links to the site. When I clicked on these it said the files couldn’t be found.
The shed we built rests on a foundation made up of 12 solid-concrete blocks. The 4 x 8 x 16-in. blocks are arranged in three rows spaced 59 in. apart. These blocks are typically set directly on the ground, but we put down a 4-in. bed of gravel first because our site occasionally receives groundwater. The gravel will keep the soil beneath the shed from eroding or becoming soggy.
The best spot for a shed is level, well-drained ground close to where you work in your garden or yard. The location doesn’t need to be perfectly flat; the foundation design shown in the plans allows for adjustments to make the floor level. Small sheds require only a top-of-soil foundation, even in locations with freezing winter temperatures. Precast concrete deck blocks work perfectly for this.
×