After the concrete is all ready, the sole plates are then joined together with the anchor plates which protrude out of the foundation. Use the carpenter’s pencil and measuring tape to mark about one and a half inches from the board end continually every sixteen inches till the further end. These marks guide where the studs will be placed. Mark where the anchor and the mudsill meet up with a different marker from the one used initially. The studs are then taken and galvanized nails are driven through the marked areas into the center of the board until they reach the stud bottom. The studs should be secured to the baseboard.
Start by setting deck blocks on the ground, positioned as shown in the plans. While the area doesn’t have to be perfectly level, you should make the ground roughly level where each block will rest. Temporarily place some straight 2-by-6 lumber on edge in the top grooves of the blocks to orient the blocks in a straight line. Arrange two rows of four blocks parallel to each other to form both long walls, then measure diagonally across the outside corners to determine how square the arrangement is. If the two long walls are parallel, and diagonal measurements taken across corners are equal, then each corner is guaranteed to be 90 degrees. Finish up by placing one deck block in the middle of each 6-foot wall after you have aligned and squared the 8-foot walls.
Think of a shed as a useful multipurpose addition to the backyard. You could use it to store shovels and gardening supplies or all the bbq supplies. It doesn’t need to be big. In fact, a tiny shed like the one featured on ana-white should be enough. Check out the tutorial and the shed plans to find out everything you need to know about this project. If you decide to build your own garden shed, you’ll need the following supplies: 2 sheets of plywood, some wooden boards, hinges, handles, a latch, galvanized nails, roofing, wood glue and materials for the doors.

shed plans reviews

×