Make a template on the shed floor for assembling the trusses. Begin by laying out the parts for one truss. Align the bottom chord with the edge of the plywood floor. Then cut four 24-in.-long 2 x 4s. Lay two alongside each rafter and screw them to the plywood floor. Now use these short boards as stopblocks for laying out and assembling each truss. Fasten plywood gussets to each side of every truss with carpenter's glue and 1-in. roofing nails and set the trusses aside.
To be honest, I almost named this project “How to Build a Shed from Scratch with your Spouse and Not Bury them Under the Concrete.” Working together as a team in life is one thing, but working together on a home DIY project is another. It’s like being on a drunken see-saw with “stay out here and work with me, but don’t get in my way.” Or, “keep me company, but don’t talk to me” How about, “just play with the kids while I work but keep them away from what I’m working on” Or even “Get me this tool, get me that tool, where are my tools? Don’t touch the tools” As it turns out that title is just a bit too wordy anyway, so I had to shorten it up a bit.
As you can see, I have no pictures of the doors being created. This is because they took way too much trouble to make, and I didn't really have the patience to take pictures of them being built because they were tested and redone about 3 times. Lesson to be learned: leave the tolerances bigger than you think they will need to be, you can always use weather strips to help close them up later. After 3 attempts, we finnally got the doors to work properly. The one door is held in place with sliding dead-bolts to the floor and ceiling frames and the second door is attached to it with another dead-bolt.