Based on this, you can then figure out the relationship between your cabinet doors and the frame or exposed edge of the cabinet—do the doors cover part of the frame or edge, or are they inset so that you can see that frame? Depending on whether it’s a single cabinet door or a double cabinet door, the frame or edge might be covered by one or two cabinet doors. 
The cons are a few: 1. MDF is heavy in relation to wood or plywood. 2. MDF does not accept screws very well. You must use coarse thread screws and always pre-drill. Apply the hinge screws by using a hand-held screwdriver instead of a screw gun. If you don't, they can strip the hole quickly. 3. Over time the screws will come lose just from opening and closing the doors (just go around every so often and tighten the screws). 4. If water gets into the doors, they will swell and they will need to be replaced so seal them well.
The cons are a few: 1. MDF is heavy in relation to wood or plywood. 2. MDF does not accept screws very well. You must use coarse thread screws and always pre-drill. Apply the hinge screws by using a hand-held screwdriver instead of a screw gun. If you don't, they can strip the hole quickly. 3. Over time the screws will come lose just from opening and closing the doors (just go around every so often and tighten the screws). 4. If water gets into the doors, they will swell and they will need to be replaced so seal them well.
There’s no hard and fast rule on how long bar pulls should be, so go with personal preference. However, most designers keep them at two-thirds to three-quarters the width of the drawer. Notice they’re even longer in this kitchen, yet the length works. A good idea is to purchase a few knobs and pulls, bring them home and try them out before replacing your entire kitchen’s hardware.

If you’re looking for a style that’s hot right now, look no further than modern cabinet hardware. This look features sleek, straight handles in horizontal lines, usually in a stainless steel or chrome finish. The hardware is skinny and will likely stand out against the color of your cabinetry. Another option is a rounded, long and vertical handle in the same finish.
We also painted our kitchen cabinets white, and I love the crispness of white cabinets. We used latex paint since we ended up doing most of the work while I was pregnant/nursing a newborn and I didn’t want to deal with the oil-based chemicals and odors. It’s definitely not ideal–the hard, oil-based finish is much more practical for kitchens and cabinets. I’m not a perfectionist so it doesn’t bother me (too much!), but I would definitely recommend taking the time to do oil like you did–yours should last forever 🙂
What they are: Sturdy yet glamorous pulls that complement many styles of cabinetry. Here linear flat bar pulls not only underscore the contemporary feel of the kitchen, but oversize pulls eliminate the need for two pulls on a wide drawer. A good rule of thumb is to use two knobs or pulls on drawers 18 inches wide or wider. But if you choose superwide pulls like these, one is enough.
Solid brass, bronze and stainless steel knobs are durable and long lasting, even under heavy use. If elegance is your thing, then opt for knobs made of crystal or marble to take your cabinet décor to the next level. These materials look sophisticated and classy. This simple change of replacing cabinet knobs is easy to implement on your own, and it will cost a whole lot less than replacing your cabinets entirely.
Prior to making the purchase of your new cabinet hardware, take some careful measurements of the existing hardware. Write down sizes, as well as the spacing of the screws. This should eliminate the need to drill new holes. Accurate measurements are essential to avoid additional work or the need to return and exchange your hardware purchase. In fact, it is a good idea to bring some of your old hardware with you for size comparison purposes, unless you are shopping online for your hardware. In that case, simply have the hardware next to you.

​If you like the idea of mixing metals, just make sure that the mix looks intentional instead of haphazard.  To make your design of mixed metals look intentional, choose 2 or 3 metal finishes and use those finishes in at least 2 or 3 areas within the space.  That way, each metal finish has coordinating partner in the same space.   Take a look at the 3 photos below.
If you're having trouble selecting the perfect cabinet hardware, for quality and value, you can’t go wrong with a cabinet hardware sample box. The cabinet hardware sample box lets you try out multiple styles and finishes in your home, select the one you love, then visit homedepot.com or your local Home Depot store to purchase the full amount needed.
Custom kitchen cabinetry doesn’t come cheap, but if you’re planning to stay put in your home for a long while, it’s worth spending to get exactly what you want, including the built-ins that enable you to live clutter-free. At the other end of the spectrum, we show you ways to modify Ikea kitchen components for a custom look (we’ve found almost a dozen new companies that offer doors to pair with Ikea’s cabinets).
Often, the hardest part in updating your kitchen hardware is deciding what will look best in your kitchen. The installation can be a simple DIY that will likely take less than two hours. However, if your kitchen cabinet hardware requires more than just a few screws but rather new fittings on your cabinets or drawers, contact a pro to ensure all of your new hardware fits perfectly.
Some kitchen designs are beginning to display personality through eclectic and artistic approaches to kitchen hardware. Recent trends include nautical-themed rope drawer pulls and door handles, painted designs, numerals, insignias or monograms on drawer pulls. And pulls and handles made from antique buttons, glass or crystal will create a truly unique look that's sure to catch the eye and spark conversation.
New cabinet door hinges are costly, and you can save a substantial amount of money by repainting old hinges yourself. The preparation work will be the most time-consuming part of the process, but skipping this step could cause you more work later. Don't waste time using all-purpose primer; use a rust-inhibiting metal primer to ensure that the paint adheres. A top-quality paint will give the hinges a professional-looking finish.
One of the most popular styles now is lacquered or aged brass. "Ten years ago," Huh says, "it was all about nickel: brushed nickel, shiny nickel. Now it's the resurgence of brass." Designers are using "bold tones, and things that look worn," she says, by installing unlacquered brass that tarnishes over the course of a year, or paying extra for "pre-antiqued" brass that already has a colorful patina.
Most knobs and pulls are only a few dollars apiece but when you consider the sheer number that you’ll need, those costs add up fast. For each standard lower cabinet with two doors and one drawer, you’ll need three pieces of hardware — and two more knobs or pulls for the matching upper cabinet doors. With that in mind, here are a couple of factors to consider:
5. Be aware of the appliances and fixtures in the kitchen. Pulls and knobs are not the only hardware in your kitchen. Take into account the finish on appliances, light fixtures, and your sink and faucet. While mixing metal finishes is trendy right now in kitchen design, be sure not to overdo it. If the colors clash, it could disrupt the cohesiveness of your kitchen and take away from the beauty of your new cabinets.
Installing new Knobs and Pulls are a super easy way to update your kitchen cabinets without spending a fortune. Our kitchen cabinets didn’t even have knobs and pulls installed so I was happy to finally add new hardware. If you’re looking for an easy update for your kitchen by getting new kitchen hardware, you will like my favorite new go-to place for hardware, D. Lawless Hardware.
Wine Logic wine racks are built-in right underneath your kitchen cabinets, eliminating the need to take up any counter space with a freestanding wine rack. Wine Logic racks come with two to five separate slide out trays that each hold up to six bottles of wine. And the best part is, Wine Logic’s horizontal design stores wine in the best possible condition, keeping the corks wet and the wine untouched by air.
You might think that after making dozens of tough decisions during your kitchen remodel, something like choosing handles for your cabinets would be easy. Yeah, so not the case. You’ll soon find out that there are more cabinet knob options than there are stars in the sky. But don’t panic. And by all means, don’t make a knee-jerk decision just to get it over with. When I used to make up design and swatch boards, I would remind clients that the hardware matters as much as the big stuff. Remember, you’ll be looking at and touching your kitchen cabinet knobs every single day. So you want to make the right choice. And after all, this is a micro design element that can have macro impact.

Pre-drilled holes: replacing the handles on cabinets comes with a few more limitations than selecting completely new cabinetry – namely that the holes might be pre-drilled. You must make sure the center measurements of the existing holes match the spacing of the new pieces. Standard hole center measurements for pulls are 96 mm, 128 mm, 160 mm, 192 mm. When choosing the size of the hardware, keep in mind the scale in relation to the size of your cabinets. Regarding door handles, there is a good chance you may need to increase the size of the bore hole in your door as well. The old standard size was 2-1/8” diameter, and the new standard size is 2-3/8” or 2-3/4”. Tutorials The Quick Door Hanger can help you learn how to do this with a boring bit.
I have tried to find replacement hinges for my kitchen cabinets along with screws, I have gone to every home improvement store and wasn’t able to find any. The first screws I tried kept snapping the heads off as I tightened down. It didn’t matter if it was manually tightening or with an electric screw driver. Why does this keep happening? I stripped the hinges with acetone and then sprayed them with a silver paint. Love the hinges now, just not any screws. What kind do you suggest?

These industrial-feeling pulls are a blend of colonial and Arts and Crafts, and come in a wide variety of finishes. While these black ones are a good choice with the black appliances and lighting, don’t feel your knobs must match all the finishes in your kitchen; it’s OK to mix things up. Just don’t mix the knobs and hinges on the same door; those definitely should be coordinated so one doesn’t detract from the other.
If you don’t want to match to your faucet, then think about some of the other components in your kitchen. For example, if you have a black stone countertop, then antiqued metal or even satin black knobs could help tie the room together. Alternatively, base your color and finish choice on the cabinets themselves: Dark hardware to match dark wood or light hardware as a contrast. Choose more rustic finishes like antiqued or hammered metal to go with traditional cabinetry or go with sleek brushed metal for a more modern look.
Cup pulls are a nice complement to Shaker-style cabinets, particularly in a country-style kitchen. Recessed hardware can make for a particularly elegant and modern look, but also tends to be a bit on the pricey side. Slim, modern finger pull type hardware, which mounts to the top of a drawer or the edge of a cabinet, is a nice choice for flat-front cabinets in a modern kitchen.
Hardware can have a huge impact on the look and feel of your kitchen, which is why we often recommend replacing hardware as a quick upgrade for rental kitchens, or when you aren’t able to remodel. So when you’re planning a new kitchen, or a re-design, don’t let your hardware be an afterthought. Here are a few guidelines to help you select the right hardware for your kitchen.
We were delighted with the professional quality of Meridian’s services. Your team was always responsive and courteous and went out of their way to ensure that our needs were met. Meridian worked closely with our architect to anticipate issues and deal with them in a timely manner. Our home was built in record time and we are very happy with the quality of workmanship.
Hanging knobs on a flat-front cabinet is pretty straightforward: You’ll want to position the knob in the bottom corner (for upper cabinets) or top corner (for lower cabinets) of the door. Knobs should be placed equidistant from both sides of the cabinet. A guide like this one can help you to get the measurements right. The exact distance will depend on the look you want and the size of your knobs: Test one or two before you drill a whole kitchen’s worth of holes.
I watch you every Sunday morning. I used to help run a construction co. here in Knoxville,TN. I am now my Moms cargiver(87). I lost my dear sweet husband last November. I am trying to sale my house. I am just stressed trying to find replacement wrap-around hinges and pulls for my kitchen and bath. I also am going to replace my laminate tops. Do you have any sources I should check. You two remind me of my sweet dad and me from years ago. Please HELP!!!!!!
You may also have seen cabinets that are so modern and minimalist that they have no knobs or pulls whatsoever—and they look like they’re impossible to open! The trick is, in fact, a mechanism with a spring located on the inside of the cabinet. When you push on the corner of a cabinet, you compress and then release the spring, which in turn pops the cabinet open. In order to close the cabinet, you simply push it closed until you hear the little "click" that means the spring is back in its locked position.
When I’m talking about metals, I consider the silver metals as one grouping. So, when you have stainless appliances (silver), a chrome faucet (silver) and brushed nickel lighting (silver) those all count as one metal in my book- SILVER. I personally think Nickel is the most timeless of the metals. Brass has really gained in popularity with interior designers, but is probably a trendier choice. I’ve seen a rise in the popularity of black hardware especially in this age of farmhouse- EVERYTHING (Thanks Chip and Joanna). I think every room in your house should have a little black in it, so if you can bring in the black with your second metal in your kitchen, DO IT!!
×