Concealed hinges can be mounted on the surface of the door or a pressed into a “cup” that is drilled into the door. These are often called “cup hinges”. The cup diameter is generally 35mm but that can vary as can the drill depth required to accept the hinge. Most concealed hinges have built in adjustability so you can slightly change the position of the door without relocating the hinge.
Based on this, you can then figure out the relationship between your cabinet doors and the frame or exposed edge of the cabinet—do the doors cover part of the frame or edge, or are they inset so that you can see that frame? Depending on whether it’s a single cabinet door or a double cabinet door, the frame or edge might be covered by one or two cabinet doors.
Pick a color scheme and stick with it. This tip is twofold, as it helps tremendously in narrowing down your choices while simultaneously expanding your options. Pick a large swath — say, the entire lower half of the kitchen — and commit to a color scheme. If the drawers in your kitchen are white, and all the hardware shares the same type of finish, the presence of different types of knobs and handles will be a pleasant sight, rather than a distraction.
We also did that. Our handles are those stainless steel round bars. Loved the look with our white slab door/drawer fronts! Turned out there was big problem with sides of the horizontal drawer pulls snagging pants pockets. So, replaced those with centered flush type steel rectangular pulls that we mounted on the drawers after using router to make mortise holes No more snagging pockets!
Since most kitchen cabinets are not sold with hardware, it’s up to homeowners to decide which knobs and pulls to pair with their selection. This is not always the easiest decision, since there are so many unique styles and finishes to choose from. To help you on your search for the perfect hardware for your kitchen cabinets, here are some tips to follow.
Handles are sold by the center to center measurement(1). Center to center can be spelled out or the universally known “C/C” could be used. Knobs are sold by the diameter(4) of the knob.The measurement could be in inches or millimeters (MM) CabinetParts has both measurements listed for your convenience. (Tip: to convert millimeters to inches use this formula: MM ÷ 25.4)Here is a diagram showing how these are measured:The overall length(2) and the projection(3) are offered when they are available from the manufacturer.Choosing a finish is going to be entirely up to you. Maybe your cabinets need a satin nickel look for a more modern look or maybe you are in the mood for flat black finished hardware for a more southwestern feel, or maybe weathered copper is your fancy. There are many, many choices for finish to make your kitchen look like a million bucks.The type of handle or knob will depend on what you like or maybe the motif of the rest of the room or house. There are modern, eclectic, or traditional looks and more.Most collections will have a pull and a knob that “match” so you can have the same finish throughout the room. You do not always have to choose pieces from the same collection, just remember to always choose the finish from the same manufacturer. Even though different manufacturers may have finishes that have the same name, they will often vary in the color and shade.These choices will be among the most important of the entire project. A knob and pull will put the finishing touch on the project and be one of the first things people will notice.Sometimes the hardware is noticed before the color or type of cabinet or door.Here is a listing of all of the manufacturers CabinetParts.com offers: Top Konbs, Amerock, Schaub and Co, Atlas Homewares, Notting Hill, Berenson, Jeffrey Alexander, Century Hardware, Hickory Hardware, Laurey Hardware, Liberty Hardware, Elements, Stone Mill Hardware, Hafele, R. Christensen, MNG Hardware, Acorn Mfg.Some of the companies listed above also offer Bath Hardware and Decorative Home Accents that may help complete a project.
Whereas crystal is made primarily of silica and lead oxide, glass is largely composed of silica and soda lime. The lime is the reason glass can have a greenish tint when light is shining through it, whereas crystal is clear. Glass can provide the perfect accent to a room, and is an excellent secret weapon if you are wondering how to add a “pop” without overdoing it.
As latches like these are elements that people come into contact with every day — literally gripping them for support or activating them with a gentle nudge — architects should keep both aesthetics and functionality in mind when specifying these seemingly simple components. To help you as you search for kitchen hardware on Source, here are a few savvy choices that fit well with modern clean spaces; ones that, even when situated in repetitive rows, won’t take attention away from sleek cabinetry design:
Choosing your kitchen hardware is a great way to customize the look of your cabinetry and drawers. From pulls to knobs and handles, you can get your kitchen cabinet hardware in almost any shape you desire. Choosing the right shape mainly depends on personal preference. I once had handles that we’re a bit snug on my finger when I opened a cabinet. As a result, every time I shut a cabinet, the hardware would tug my finger. After a short time, enough was enough and I switched out my handles for knobs with no further issues. You’d never imagine a small detail such as cabinet hardware type would cause so much frustration, but it truly does make a difference.
“What is your overall style? Traditional, contemporary, arts and crafts, eclectic, cottage, French, Mediterranean, Western, Art Deco or coastal,” asks Brandino Brass co-owner Eric Brandino. He encourages clients to think about the style of their home or the style they would like to incorporate. “Is there a consistent style throughout or does it vary from room to room? Transitional style has been one of the most popular looks recently,” he says of what’s trending in hardware. “Clean lines with just a touch of traditional features and finishes, such as an unlacquered brass or bronze.”
Specializing in hardwood furniture, trim carpentry, cabinets, home improvement and architectural millwork, Wade Shaddy has worked in homebuilding since 1972. Shaddy has also worked as a newspaper reporter and writer, and as a contributing writer for Bicycling Magazine. Shaddy began publishing in various magazines in 1992, and published a novel, “Dark Canyon,” in 2008.
Hardware can have a huge impact on the look and feel of your kitchen, which is why we often recommend replacing hardware as a quick upgrade for rental kitchens, or when you aren’t able to remodel. So when you’re planning a new kitchen, or a re-design, don’t let your hardware be an afterthought. Here are a few guidelines to help you select the right hardware for your kitchen.
Some styles of kitchen cabinets are designed to open at the side of the door, so they don’t have outer knobs. When re-facing cupboard doors as part of a remodeling project, new knobs can still be added to these self-opening styles. Consider adding knobs or handles that create visual interest. Careful planning is needed as holes will need to be drilled in the cabinet doors to add the new knobs.
When exploring kitchen cabinet hardware ideas, your first task should be to decide how closely aligned in terms of style you want your hardware and the cabinets themselves. For example, a traditional Shaker style cabinet can be complemented with simple, understated brushed metal hardware—or it can provide a blank canvas for all manner of creative approaches to door handles and drawer pulls. The choice is yours, and while it's true that sticking with a one-to-one approach with cabinets and hardware may save you time and simplify the design process, exploring other options may allow you to express more of your own design aesthetic in the kitchen.
Swapping these items out is often easy, and Los Angeles-based designer Betsy Burnham says her clients are frequently surprised at the visual impact of something as simple as carefully chosen hardware. Last summer, she added door pulls made of rope tied in small nautical knots to the built-in cabinets at a California beach house, inexpensively adding a dash of personality to the space.
Most knobs and pulls are only a few dollars apiece but when you consider the sheer number that you’ll need, those costs add up fast. For each standard lower cabinet with two doors and one drawer, you’ll need three pieces of hardware — and two more knobs or pulls for the matching upper cabinet doors. With that in mind, here are a couple of factors to consider:
Shake a can of rust-inhibiting metal spray primer for the amount of time recommended by the manufacturer. Position the can the recommended distance away from the hinges -- it varies among manufacturers. Spray a light coat of primer on the hinges and screw heads using steady, even sweeps. Make sure you spray the sides and edges. Shake the can frequently while you spray. Allow the primer to dry for the amount of time recommended by the manufacturer. Apply a second coat of primer and allow it to dry completely.
Installing new hinges can be easy, but only when choosing the correct cabinet hinge upgrade. The door style, door thickness, and hinge type, all play a role. Once this information is obtained, you should be able to find a soft-close hinge that is a direct retrofit to the existing hinge, or choose one of the many independent dampers and keep your current hinges.
Cliffside is one company that works exclusively with high-quality producers who make sturdy, kiln-fired glass. This glass comes in many different colors to suit your palette, as well as different shapes and sizes. Because the glass is strong, it can stand up to the rigors of dropped kitchen items, quick yanks and more. This durability also means it can be used for more than just knobs — there are glass handles available as well.
Dreamy DIY: Have you ever seen something that makes you want to break out the craft kit and get to down to business? Well these leather drawer pulls with brass rivets are so luxuriously handsome it makes us want to rip out and redo every single pull in the house. I can only imagine how delightful these will begin to look when worn with use — a little imperfection to balance and roughen up such a posh space.