Disclaimer: Although it is my intention to provide accurate plans and clear instructions, not all plans have been tried and tested. Using plans or information found on SawdustGirl.com indicates that you agree with the Terms of Use policy and will accept full responsibility for the process and outcome of any project you attempt. All plans are for private use only. Plans and information published on SawdustGirl.com may not be reproduced, republished or distributed in any manner without written permission from Sandra Powell, Sawdust Girl. Actual projects built using Sawdust Girl plans may be published on your own site without instructions or "tutorial" as long as you provide a link to my original post with full post title or "SawdustGirl.com" as link title.

For this step you’ll want to clamp your door to the work surface, unless of course you want your door to spin around in circles and possibly punch you in the stomach. Next, measure equal distance from the top and bottom of the door and mark the center hole with the jig, also mark the 2 side holes where you’ll screw the hinge in place (I found that using an awl to mark the holes made it easier to drill). We drilled for our hinges over the same location as the old ones, which were NOT equal distance from the top and bottom, but at least every door was at the same unequal distance.

Interior Door knobs and levers can range from less than $20 to $200.  You can find cabinet knobs and pulls from less than $2 each to more than $20 each.     Solid knobs and pulls are better quality than hollow hardware.  Although you generally get what you pay for with hardware, if your budget is tighter, you might want to choose less expensive cabinet hardware since it’s relatively easy for homeowners to trade it out for better quality hardware in the future.
This step will work best with raised panel or recessed panel cabinets, my cabinets are raised panel. OK, so I have a little confession to make, I outsourced this step, my routering skills are not top notch and I wanted the kitchen to look good, not like something put together by Dr. Frankenstein. The good news is it was very inexpensive and I was able to get 10 little doors done for less than the cost of a new upper cabinet. If you’re an ace with the router then you know exactly what to do, so have at it!
White cabinets really help bring out the light and area available in a room. My kitchen is currently really dark and doesn't let much light in. I feel if I were to add windows and make the room a lighter color it would appear a lot happier and feel like I have more room. Thanks for the inspiration I am going to start looking for pieces to make my kitchen lighter like yours!
Choosing your kitchen hardware is a great way to customize the look of your cabinetry and drawers. From pulls to knobs and handles, you can get your kitchen cabinet hardware in almost any shape you desire. Choosing the right shape mainly depends on personal preference. I once had handles that we’re a bit snug on my finger when I opened a cabinet. As a result, every time I shut a cabinet, the hardware would tug my finger. After a short time, enough was enough and I switched out my handles for knobs with no further issues. You’d never imagine a small detail such as cabinet hardware type would cause so much frustration, but it truly does make a difference.

One of the biggest enemies of a clean kitchen lies in careless cabinet hardware selection. Apart from choosing a gaudy color or ill-fitting shape, the one detail that can make or break the look of a cabinet door actually is the humble piece of hardware that is chosen to open and close it. From round knobs to long pulls and magnetic mechanisms, there’s a world of choices to make when it comes to honing in on the perfect hardware for kitchen cabinets. Some can stick out like a sore thumb, while others can be completely invisible.

There are a couple of ways to go about choosing the right color and finish. One school of thought advises you to choose based on the color and finish of the kitchen’s faucet. Given that most faucets are either silver or brass in color, this advice can be limiting, especially if you have your eye on stone knobs or another finish that is not common in faucet design.
The size of your cabinets will influence the size of your knobs. If your cabinets are smaller in scale you’ll want to opt for hardware that is likewise, such as minimal-scale circular knobs. Longer hardware is necessary when you have extra long cabinet doors—or can be used if you want to make a more of dramatic statement. Most cabinet doors are 24”, so you want a knob about 2”-3” size knob. For a larger cabinet door you can size up to 3½” or 4”. For a cabinet door under 20”, source hardware that’s closer to 1” to 2” size in diameter or length.
Hi, Randi! I love all your comments. They are MAKING my day! (Especially how can I be old enough to have a daughter with her own place lol This daughter also has two kids which makes me grandma. Oy. Yes, I’m THAT old!) Anyway, I’m so glad you commented and shared about your kitchen. I’m so glad you’re going for what you want! Sometimes we do indeed get paralyzed but we have to remember who our homes are for…..and that’s US! I think we want to enjoy our kitchen especially, since most of us spend time in there with our families, or at least cooking for our families!
Hanging knobs on a flat-front cabinet is pretty straightforward: You’ll want to position the knob in the bottom corner (for upper cabinets) or top corner (for lower cabinets) of the door. Knobs should be placed equidistant from both sides of the cabinet. A guide like this one can help you to get the measurements right. The exact distance will depend on the look you want and the size of your knobs: Test one or two before you drill a whole kitchen’s worth of holes.
Then I drilled and drilled. If your drill is a wimpy one, be prepared for this to take a minute…or five.  I realized what a difference a decent drill makes during this process as I had three different ones going–one with a bit to drill the pilot holes, one with the hinge bit and one to use as a screw gun for screwing the screws into the cabinet doors. If you have lots of doors to do, it might be a good idea to borrow a second and/or third one from a friend or you’ll spend lots of time playing musical bits. If you have multiple drills, use the most powerful one for the large hinge-drilling bit.
Budget: Get an idea of the full scope of your makeover project first. Then get an idea of how much of that budget can go toward your door and cabinetry hardware. The cost of individual pieces can be broad, as hardware can be produced by many methods. Material and intricacy of the handle itself affect price as well. A Gross Electric hardware expert will help you get the most bang for your buck.
Installing new hinges can be easy, but only when choosing the correct cabinet hinge upgrade. The door style, door thickness, and hinge type, all play a role. Once this information is obtained, you should be able to find a soft-close hinge that is a direct retrofit to the existing hinge, or choose one of the many independent dampers and keep your current hinges.
Hanging knobs on a flat-front cabinet is pretty straightforward: You’ll want to position the knob in the bottom corner (for upper cabinets) or top corner (for lower cabinets) of the door. Knobs should be placed equidistant from both sides of the cabinet. A guide like this one can help you to get the measurements right. The exact distance will depend on the look you want and the size of your knobs: Test one or two before you drill a whole kitchen’s worth of holes.
One popular subset of modern drawer cabinet pulls are cup pulls, sometimes also known as half-moon pulls because of their half-circle form. Rather than wrap your fingers around a bar, as is the case with most pulls, users slip their fingers in the underside of a cup handle, pulling towards themselves. A similar but even more modern version of this is the finger pull, where a U-shaped pull gets installed to the inside edge of a drawer, leaving an L-shaped pull that your fingers slide under. These two types of modern cabinet pulls are installed using a specific mounting method, and they can only be installed in one direction, facing down.
Updating the hardware on your kitchen windows can take them from standard to standout in seconds! Typically, window sash locks and lift pulls blend in with your window color, but switching these traditional styles up with an elegant bronze or a satin nickel finish will add interest and pizzazz to your windows. You can also choose a finish that matches the rest of your kitchen hardware for a pulled together style.

Hi, Randi! I love all your comments. They are MAKING my day! (Especially how can I be old enough to have a daughter with her own place lol This daughter also has two kids which makes me grandma. Oy. Yes, I’m THAT old!) Anyway, I’m so glad you commented and shared about your kitchen. I’m so glad you’re going for what you want! Sometimes we do indeed get paralyzed but we have to remember who our homes are for…..and that’s US! I think we want to enjoy our kitchen especially, since most of us spend time in there with our families, or at least cooking for our families!

Cabinet hardware is composed a variety of materials -- most of which are metal alloys. Brass hardware typically has a lacquer or plating applied to its surface that makes it very durable in a kitchen. It is antimicrobial and helps to reduce the spread of germs. Bronze hardware is also antimicrobial, offers a substantial look and feel, and works well for cabinets made of thicker woods. Stainless steel is another option because it is so durable. Pewter and nickel are popular choices, too. Or, you can choose knobs made from glass or crystal for a vintage look. 


For customers who have homes near the ocean, Cliffside recommends choosing non-metal items such as marble or wood for your projects. Salt air acts as an abrasive, and quickly erodes the lacquer coating. If you absolutely need (or desire) metal hardware, Cliffside recommends solid stainless steel, or certain solid brass finishes such as Black, Polished Brass, or Polished Chrome. Note that, even in optimum indoor conditions, no Cliffside finish has a lifetime guarantee under any circumstances.
You’ll also want to think about how visible your hinges will be—do you want them to be a major design feature and mounted directly to both the outside of the frame and the outside of the cabinet, known as a surface-mounted hinge? Or take a more minimalist design approach and have them virtually invisible from the outside when the cabinets are closed, known as a concealed hinge? Are you worried about the noise of cabinet doors closing, and think that soft-closing hinges are important? 

The other option for changing kitchen cabinet knobs is to purchase new ones. The two main types of cabinet fixtures for kitchens are circular pulls and metal bars. The round pulls tend to be old-fashioned, while the metal bar handles are often more contemporary. Cabinet pulls can be made more modern by painting them metallic silver. Metal bar cabinet door handles are usually silver-colored and narrow; this style is often seen with darker wood toned cabinets.
Prevent cabinet doors from slamming shut with integrated Prevent cabinet doors from slamming shut with integrated soft-close technology from Everbilt. Designed for a full overlay these hinges are retro fit able and allow any level DIYer to do away with the heavy slamming of cabinet doors. The complete overlay leaves your cabinets with a sleek modern look.  More + Product Details Close

Once you’ve worked out which types of hardware are comfortable to use, it’ll be time to start thinking about shapes in relation to the shape of your cabinetry. In general, knob and pull styles should be matched to kitchen cabinet styles. What this means is if you have selected a plain cabinet style, for example, shaker or flat, ultra-modern doors, then you’ll want square, plain hardware to match — perhaps something like Emtek’s brass bar knob or a similar style. Recessed panel doors or doors with curving and intricate trim will often do well with more ornate hardware styles.
Oh how true this is for me right now. Oh how true. Luckily I’m here :-). By the way, I can’t handle your kitchen, it’s too perfect. I’ve never seen anything like it and it’s the best thing I’ve ever seen. I’m doing a modern eclectic boho kitchen, predominately white, some wood accents, maybe darker lower cabinets, maybe gold hardware (that’s where I’m stuck), and then pops of beautiful colour like you have here. I’m excited!
Good morning and happy Monday, lovely people! I hope y’all had a wonderful Thanksgiving week. Ours was a little on the insane side, but it ended perfectly. We moved to our new house {Memaw’s house} a little over a week ago. It was crazy getting settled just in time to host our family’s Thanksgiving dinner. It was hard without Memaw. Tears came easily and our family time was just really sweet. I’m very thankful.
Then I drilled and drilled. If your drill is a wimpy one, be prepared for this to take a minute…or five.  I realized what a difference a decent drill makes during this process as I had three different ones going–one with a bit to drill the pilot holes, one with the hinge bit and one to use as a screw gun for screwing the screws into the cabinet doors. If you have lots of doors to do, it might be a good idea to borrow a second and/or third one from a friend or you’ll spend lots of time playing musical bits. If you have multiple drills, use the most powerful one for the large hinge-drilling bit.
One of the last things considered when shopping for kitchen cabinets is the hardware. But kitchen cabinet hardware can make a big impact on the look and feel of not just your kitchen cabinets, but the entire room. The shape of and finish on your pulls, knobs and handles can put the final touch on your kitchen design. The very same cabinet might have a vintage feel with porcelain knobs, or a contemporary look with brushed nickel pulls. You can give your kitchen a very personalized treatment with something custom, like artistic glass knobs, or handworked metal in oil-rubbed bronze. Think of the hardware like jewelry for your cabinets. Let it speak for your style - be that contemporary, modern, vintage or traditional. Here are some of our favorite examples of great kitchen cabinet hardware from around the web.
×