Painting cabinets yourself is cost-effective -- a few gallons of paint, sandpaper, cleaner -- but the process is time-intensive. You can paint most cabinet surfaces, but proper prep is key to success. For laminate and melamine finishes, be sure to rough up the surface with 150-grit sandpaper, and apply a good bonding primer before topping it off with the color of your choice.
If you decide to install these hinges throughout, you’ll also get the privilege of a handy fine-tune adjustment feature, the BLUMOTION function can be turned on / off with an activation switch so you can accommodate different weights of doors. But the soft-close feature doesn’t have variable adjustments like some of the other soft-close hinge systems. Once the soft-close is turned of you’ll be left with a standard self-close hinge.
I love your site and your super helpful advice. We’re installing full overlay cabinets in our kitchen and we’re trying to select hinges for the upper cabinets — particularly the cupboard doors on the end which when closed is perpendicular to a wall. Since the door aren’t inset, I’m concerned we won’t be able to open the cupboard a full 90 degrees. Basically, the issue is how to solve the problem of the door swing? Are there any hinges that could solve this problem? I can send elevations if that helps. Thanks so much in advance!
This step will work best with raised panel or recessed panel cabinets, my cabinets are raised panel. OK, so I have a little confession to make, I outsourced this step, my routering skills are not top notch and I wanted the kitchen to look good, not like something put together by Dr. Frankenstein. The good news is it was very inexpensive and I was able to get 10 little doors done for less than the cost of a new upper cabinet. If you’re an ace with the router then you know exactly what to do, so have at it!

And starting to play with my new HVLP turbine spray system.  (Whenever I say HVLP turbine, I think of the movie “A Christmas Story” and how Ralphie describes his Red Ryder BB gun – “an official Red Ryder, carbine action, two-hundred shot range model air rifle.”  I think I’m equally enamored with my new gun, even if it doesn’t have a compass and a stock. 😉
Love the drawer pulls and glass knobs. I love the look of glass knobs too! I am so impressed that you spray painted the oven doors? They look great. As for that wooden valance over the sink – I would 86 that in a heartbeat! Nothing says out of date faster than that thing. Wondering if you could cut the ornate part off and maybe paper or paint with your pop color? What about under counter task lighting. I have halogen which are nice but also get very hot. I have seen others with flush mount hardwired fluorescent lighting which work just fine and a lot less expensive.

Knob or pull? Bronze or silver? Small or big? Kitchen cabinet hardware is more than just a pretty decoration; knobs and pulls keep your cabinet cleaner and protect the finish. Plus, while they’re little, they can actually make a big impact on your kitchen’s appearance. But with thousands of options out there, how can you select the right hardware to make the best impact? Take these things into consideration before you make your final kitchen cabinet hardware selection.
At a home renovation in Connecticut, cabinet fabricator Michael Madore experimented with what he calls an "aggressive" metal-sanding process to pull out the grain from the whitewashed oak plywood. For the hardware-free cabinets, Julie Salles Schaffer looked to a drawer pull detail derived from Giò Ponti’s work—though she admits the radial edging is an effect entirely her own.
If you think about it, you open your cabinet doors multiple times a day. Over a few years, that can take a toll on those hinges holding your doors in place. Replacing them with hinges that are made from a quality material like solid brass will not only help your cabinet doors function better, but it will make them look better, too! Choose a hinge color that matches the other hardware in your kitchen for a unified look and feel. For easy installation, look for hinges that are adjustable so you can use the same hinges to fit multiple sized doors and cabinets. This small change will make your cabinets look updated and keep them functioning properly for years to come.
2) I also note that it does not take long before doors start to sag & the gaps become irregular. Not hard to fix just lie on your back, take all doors off, then tighten everything & replace – then take a cold shower you will need it! It seems the cup sections remain well fixed but the fixing plates on the inside of the cupboard sides just work loose. This ought not to happen but it does & with all the concealed overlay hinges I have seen. Is there an answer? I suspect the hinges are under rated, 2 hinges for doors that typically are nearly 10Lbs may be the reason. Can you please comment.
White cabinets really help bring out the light and area available in a room. My kitchen is currently really dark and doesn't let much light in. I feel if I were to add windows and make the room a lighter color it would appear a lot happier and feel like I have more room. Thanks for the inspiration I am going to start looking for pieces to make my kitchen lighter like yours!
Most of your pulls and knobs, though, will go on standard sized cabinetry, which will be 3 feet wide or less.   The most common pull sizes for standard cabinetry are 3”,  4”, or 96mm and 128mm, again measured from the center of one screw hole to the center of the other. But many of today’s pulls tend to be on even larger than 4 inches.  Standard knob sizes are less than 1.5 inches in diameter.
I have a solid oak kitchen from the late 1980s. I would like to update the cabinets by painting them but my hinges are exposed. Is it possible to change any exposed hinge to a hidden hinge, or are there some styles that won't be replaceable? Also, has anyone else painted kitchen cabinets with exposed hinges in such a way that it looks good? Thanks!
For knobs on a cabinet with a stile, like Shaker-style cabinets, allow the stile to be a guide for hanging the knob. If the knob is too large to comfortably fit in the corner where the two stiles meet, then hang the knob centered on the vertical stile, with the bottom edge of the knob aligned with the top of the intersecting horizontal stile. (Or the top of the knob aligned with the bottom of the stile, for lower cabinets). The knobs in this kitchen from Ivory Lane are a good example.

For this step you’ll want to clamp your door to the work surface, unless of course you want your door to spin around in circles and possibly punch you in the stomach. Next, measure equal distance from the top and bottom of the door and mark the center hole with the jig, also mark the 2 side holes where you’ll screw the hinge in place (I found that using an awl to mark the holes made it easier to drill). We drilled for our hinges over the same location as the old ones, which were NOT equal distance from the top and bottom, but at least every door was at the same unequal distance.
The cons are a few: 1. MDF is heavy in relation to wood or plywood. 2. MDF does not accept screws very well. You must use coarse thread screws and always pre-drill. Apply the hinge screws by using a hand-held screwdriver instead of a screw gun. If you don't, they can strip the hole quickly. 3. Over time the screws will come lose just from opening and closing the doors (just go around every so often and tighten the screws). 4. If water gets into the doors, they will swell and they will need to be replaced so seal them well.
Once you choose the style of hardware you want, it becomes easier to choose the right finish. There is a wide variety of cabinet hardware finishes: tarnished, polished, brushed, burnished, oil-rubbed, satin, antique or matte -- just to name a few. Stainless steel handles in a highly polished finish look great in a contemporary kitchen. Pewter and brass look more at home in a traditional setting. Bronze will patina over time, mature in appearance, and will make a bold statement in a kitchen. A black finish is dramatic on a light colored cabinet. Whatever you choose, just make sure the finish on your cabinet hardware complements the overall decor of your kitchen.

Wine Logic wine racks are built-in right underneath your kitchen cabinets, eliminating the need to take up any counter space with a freestanding wine rack. Wine Logic racks come with two to five separate slide out trays that each hold up to six bottles of wine. And the best part is, Wine Logic’s horizontal design stores wine in the best possible condition, keeping the corks wet and the wine untouched by air.


You probably noticed from the after photo that I didn’t just replace the hinges and add glass, oh no, I went big with this transformation. I replaced the hinges, added glass to the upper, upper cabinets, removed the wood valances, closed in a window and added open shelving (super simple), added upper and under cabinet lighting, new counter tops, new back splash and new appliances.  But I did all that with the original cabinets and they no longer look tired, worn out or dated. Now if I could just find something to renovate my tired, worn out, dated self…
Kitchen cabinet knobs can really change the look of your cabinets. The best knobs and handles not only suit the cabinet style, but also add to the theme or mood of your kitchen. For example, the warm appeal of hammered copper cupboard handles blends well with rustic kitchens, while the cool sparkle of crystal knobs looks elegant against dark wood cabinets.
Recessed Pulls mimic the utilitarian style of traditional office cabinetry. They’re built into the cabinet door and can be crafted from the same material to blend in or a contrasting material to highlight their presence. They’re also great for high-traffic kitchens because they don’t protrude from the doors, meaning there is little risk of them snagging on clothing.

Once you’ve selected your new handles and pulls, it’s time to remove all the old ones. Using a drill or screwdriver, slowly back the screws out, then gently pull the old hardware away from the door or drawer front, so as not to damage the finish. Keep the old screws and pulls/knobs together in a plastic baggy so it’s easy to donate or toss them depending on their condition. If you’re going to repaint your cabinet doors, do it now.
Picking the perfect cabinets for a project is hard enough, but the effort it takes to research, test and finally decide on the best piece of outward-facing cabinet hardware calls for even further inspection. While the main material for the cabinet door heavily contributes to a kitchen’s character, its hardware serves to accentuate that character further still. A key detail within one of the most important spaces of a residence, cabinet hardware sits squarely at the intersection of form and function, and making the right choice here can elevate the design of the entire kitchen.
Hi, Randi! I love all your comments. They are MAKING my day! (Especially how can I be old enough to have a daughter with her own place lol This daughter also has two kids which makes me grandma. Oy. Yes, I’m THAT old!) Anyway, I’m so glad you commented and shared about your kitchen. I’m so glad you’re going for what you want! Sometimes we do indeed get paralyzed but we have to remember who our homes are for…..and that’s US! I think we want to enjoy our kitchen especially, since most of us spend time in there with our families, or at least cooking for our families!

What they are: Art objects as much as pulls, these knobs draw attention. Placed in the center, they draw your eye to the detailing of the worn wood here. Search salvage yards for antique ones and don’t be afraid to spring for the few knobs you’ll need. If you can’t find this sort of door detailing, you can create a similar effect by placing a medallion behind each knob in the center of your doors. Look for antitwist pins to keep the knob from spinning (in fact, do this with any round knob).

Welcome to Willow Lane Cabinetry — the #1 place to buy affordable, semi-custom cabinets online! Let us help you create the kitchen of your dreams with our 100% free kitchen design tool. We offer all wood, semi-custom cabinets, fully assembled and delivered for free. Plus all the accessories you need to complete your remodel. Visit our website to see our products today!
Under-cabinet lighting serves not only a fashionable purpose by creating visual depth in your kitchen, but it serves a functional purpose as well. The added lighting will make everything from chopping veggies to reading recipes to measuring ingredients easier to see as your countertops will be under direct light from above. And as far as style goes, the right lighting can make all the difference!
When decorating your rustic kitchen, a little bit of detail can go along way! There are many round, cast iron options that have designs that look great in rustic kitchens. If cast iron is too dark for your cabinets, look for an antique pewter finish. The detail within the hardware itself will certainly add to the look. This option also works well for a farmhouse style kitchen, giving it a great country feel.
Go to the home improvement center and get a 35mm Concealo Hinge mounting kit, it comes with a forstner bit (invented by Benjamin Forstner, in case you didn’t know) and a jig for marking the drill location. You’ll also want to make sure you get 35mm European-style hinges too, but before you buy them you’ll need to determine if you have ½” overlay or full overlay doors. ½” overlay doors overlap the face frames by a ½”, full overlay doors fully overlap the face frame leaving about an 1/8” showing on the outside edge. My doors were all ½” overlay, so I bought eighty 3-way adjustable hinges from eBay. I’m not sure what I was thinking because I ended up with a LOT of hinges left over. Warm up your drill and let’s move on to the next step.
And then there’s appliance hardware. Appliance pulls are not just hardware pulls that have a higher price point. It is a more durable hardware that look identical in style to your standard pulls, but are designed for the larger items in your kitchen like refrigerators, dishwashers, pantries, and oversized drawers. They come in a range of sizes from 6” to 36” and are constructed to hold a heavier weight, typically necessitating longer screws and a backplate for installation. The screws can be shortened to the needed size, but its best to follow the instructions and have these pieces installed by a professional to avoid hiccups.
×