The style of cabinet hardware you pick will depend a great deal on the style of your kitchen, and also on the kind of cabinets you choose. Traditionally styled cabinets with more intricate face profiles call for traditional hardware: Cabinets with more simply styled or completely flat faces look best with minimal, streamlined knobs and pulls. Some very modern cabinets don’t require hardware at all: Instead, they have grooves on the edges of the door, or open by push latches.
Pre-drilled holes: replacing the handles on cabinets comes with a few more limitations than selecting completely new cabinetry – namely that the holes might be pre-drilled. You must make sure the center measurements of the existing holes match the spacing of the new pieces. Standard hole center measurements for pulls are 96 mm, 128 mm, 160 mm, 192 mm. When choosing the size of the hardware, keep in mind the scale in relation to the size of your cabinets. Regarding door handles, there is a good chance you may need to increase the size of the bore hole in your door as well. The old standard size was 2-1/8” diameter, and the new standard size is 2-3/8” or 2-3/4”. Tutorials The Quick Door Hanger can help you learn how to do this with a boring bit.
Knobs are installed with a single screw through one focused entry point on a door or drawer. Pulls are installed with two screws through two points of contact on a door or drawer. Before any holes are drilled, make sure you give detailed instructions to your homebuilder or remodeling professional so that they know the correct type of handle to install on each cabinet door or drawer. You will also need to specify the position of the knob or pull so that they are installed in a consistent manner throughout the kitchen.

Cabinet hardware is composed a variety of materials -- most of which are metal alloys. Brass hardware typically has a lacquer or plating applied to its surface that makes it very durable in a kitchen. It is antimicrobial and helps to reduce the spread of germs. Bronze hardware is also antimicrobial, offers a substantial look and feel, and works well for cabinets made of thicker woods. Stainless steel is another option because it is so durable. Pewter and nickel are popular choices, too. Or, you can choose knobs made from glass or crystal for a vintage look. 
Eight staircases?!?Nothing says 'stupid' quite as much as that!Not being critical of the crew, but between the 'historical society' that dictates what you can and can't do (but happily send you the bill) and over the top designs that will prove to be idiotic just makes me shake my head in disbelief.This certainly won't be a house where you can 'age in place'.
I did a little google search to see what color my oven (and sink and cooktop and bathroom) used to be. It was called Mexican sand. I also once had olive green washer, dryer, freezer and refrigerator. Oh my, we thought we were really stylin’ back in the good old 70’s. I cringe when I see a photo of myself in the fashion of the day too. I miss my youthful look, but not the styles.

Cabinet hardware sizes can vary depending on your own personal design preferences, but you’ll want to choose a size that is both stylish and functional. Bar pull sizes are generally determined by the “center-to-center” measurement (the distance between the two screw holes). If you have pre-drilled cabinetry, you’ll need to buy hardware that fits the existing center-to-center measurement. Otherwise, you’re left to your own devices in choosing the size of your cabinet hardware. Here are a few general guidelines to follow:


It’s easy to get caught up in selecting the larger items, such as cabinetry, countertops or flooring for your new kitchen when building a custom home or renovating your existing home. "A project isn't complete until you've selected the right hardware that strikes a personal balance between form and function. These final touches will pull the whole project together and are fantastic for imbuing it with a flair that reflects your personality," says Jonathan Pilley, Co-Owner at Push Pull Decorative Hardware in North Bethesda, Maryland. Decorative hardware comes in a variety of types, sizes, styles, materials and finishes. So, what should you pick? Read our 5 tips on choosing the right kitchen cabinet hardware.
Furthermore, hardware attracts the eye like a bright light. Functionality aside, it is the ultimate accent piece — it provides a pop to cabinets and drawers that can make or break the décor of a room. It also keeps the wood of our cabinets and drawers looking fresh by taking the brunt of the natural oils in our hands, which we leave behind every time we reach for the cabinet to grab something.
Linda, great questions! I have only had my rub n buffed hinges in use for a few weeks so far so I can’t say much for long term use yet. I can say that I haven’t had a problem with it rubbing off, but I did have to be really careful hanging my cabinet doors because I noticed that it did rub off on the white paint if I wasn’t careful. (The few spots where that happened, I just touched up the white paint.) I also didn’t have a problem getting it to shine – but I was going for a brushed nickel look which isn’t super shiny. I don’t know that you could get it shiny enough to be a chrome looking finish. Overall I have been really happy with it but I will be sure to share an update after more time passes.
Hi Angie, I think that over time the rub n buff would rub off of the hardware from repeated touching. My hinges still look good two years later, but I can still see places where the finish is starting to rub off and the hinges are almost never touched. I do think that you could update your hardware with a good spray paint though. Just be sure to clean them thoroughly and use a spray primer followed by spray paint. I have update furniture hardware this way that is still going strong almost 10 years later. Good luck!
Try to establish some sense of visual symmetry. If you are going to mix styles, the secret to having it look great is to counterbalance the mixing and matching with a semblance of symmetry. For instance, make sure all your drawers have the same number and configuration of knobs. Perhaps all drawers of the same size should share the same knob, and smaller drawers can display a different type.
Hello Mr. TretheweyMy name is terry cotto, when we built our beautiful home 16 years ago, in Sierra Madre Ca I had my claw tub installed,( my child hood remembrance) It appears, that the claw legs of the tub were not installed properly, and one leg fell off , tub was slightly tipping to the right. I had a handyman come over and reinstall the claw legs, tighten so this would not happen again. The other day, while I was bathing I noticed the seal of the drain on the outside rubber was not laying properly, plus it was leaking, ( I think this was due to the leg falling off and unbalancing the ring. Well, now I really don't know what to do about that. I believe the thing to do is remove the cover off the top drain , ok, but than what do I have to move the claw tub, impossible. How do I replace the rubber of the outside of the top drain pipe, it appears to be brittle. (Not good)Please answer my questions, and I will hire the handy man again to help me. Thank you. I have learned so much from T.O.H weekly shows, I am a loyal fan at 75. I tell my 80 year old husband, you need to watch these shows with me, and we can do it ourselves, the right way. God Bless you all for the great job your doing, I need to know how to do it right, so it doesn't happen again. a picture would be good, I can see exactly how its done?
Hi Angie, I think that over time the rub n buff would rub off of the hardware from repeated touching. My hinges still look good two years later, but I can still see places where the finish is starting to rub off and the hinges are almost never touched. I do think that you could update your hardware with a good spray paint though. Just be sure to clean them thoroughly and use a spray primer followed by spray paint. I have update furniture hardware this way that is still going strong almost 10 years later. Good luck!
What is the existing decor of your kitchen or bathroom? For instance, if your kitchen has a white, Scandinavian minimalist aesthetic, you should try matching your hardware with it — in that case, perhaps something slender, jet-black and low-profile. Mismatching styles can look “off” and can create a confused sense of the room’s personality. However, it can also be done well. We’ll go into more depth on this below.
I have a solid oak kitchen from the late 1980s. I would like to update the cabinets by painting them but my hinges are exposed. Is it possible to change any exposed hinge to a hidden hinge, or are there some styles that won't be replaceable? Also, has anyone else painted kitchen cabinets with exposed hinges in such a way that it looks good? Thanks!
Sandra, I’m so glad that I came across your blog! You’ve given so much great information that I can use every day in my job doing kitchen cabinet sales. And then there’s the whole DIY part for me personally! I’m really hoping that you can answer my question, though. I have a customer who is refacing her cabinets. She has frameless cabinets and used to have exposed hinges. She wanted concealed hinges so we had the hinge holes drilled 1″ (center) from the edge. She has her new doors but when she hangs them, there’s a 1/4″ gap between the door and center stile, even after adjusting them. We were using full overlay hinges. Can you advise which type of overlay hinge to use and how to rectify the gap? Thanks so much!

Over time, switch plates and outlet covers can become dingy and dirty. Replacing your old outlet covers is a quick way to add some new life to your kitchen décor. Switch plates and outlet covers are no longer stuck just being basic functional pieces on your wall. There are many different designs, materials and finishes that can complement the look of any room. Choose switch plates and outlet covers that are made from high-quality metal materials because they are more durable and stylish than basic plastic ones. Plus, you won’t have to worry about kitchen splatter creating unsightly stains on your covers, as this material is super easy to wipe clean!


The timeless classics of solid brass styles, futuristic euro-design aluminum pieces, stunning granite and stainless steel combinations, and novelty handcrafted hardware can all be purchased for a fraction of the cost of replacing your entire set of kitchen cabinets. Give your kitchen a new look with the simple replacement of cabinet hardware. Sprucing up the kitchen has never been easier.
We also painted our kitchen cabinets white, and I love the crispness of white cabinets. We used latex paint since we ended up doing most of the work while I was pregnant/nursing a newborn and I didn’t want to deal with the oil-based chemicals and odors. It’s definitely not ideal–the hard, oil-based finish is much more practical for kitchens and cabinets. I’m not a perfectionist so it doesn’t bother me (too much!), but I would definitely recommend taking the time to do oil like you did–yours should last forever 🙂
Updating the hardware on your kitchen windows can take them from standard to standout in seconds! Typically, window sash locks and lift pulls blend in with your window color, but switching these traditional styles up with an elegant bronze or a satin nickel finish will add interest and pizzazz to your windows. You can also choose a finish that matches the rest of your kitchen hardware for a pulled together style.
Hardware can have a huge impact on the look and feel of your kitchen, which is why we often recommend replacing hardware as a quick upgrade for rental kitchens, or when you aren’t able to remodel. So when you’re planning a new kitchen, or a re-design, don’t let your hardware be an afterthought. Here are a few guidelines to help you select the right hardware for your kitchen.

Use the same guidelines for or your interior doors. If you like the idea of statement door knobs and hinges, go for lots of contrast— dark door knobs and hinges on light doors, for example.  As an aside, interior door levers, which you simply have to push down, are easier for aging hands to operate as compared to door knobs, which you have to twist.
We also painted our kitchen cabinets white, and I love the crispness of white cabinets. We used latex paint since we ended up doing most of the work while I was pregnant/nursing a newborn and I didn’t want to deal with the oil-based chemicals and odors. It’s definitely not ideal–the hard, oil-based finish is much more practical for kitchens and cabinets. I’m not a perfectionist so it doesn’t bother me (too much!), but I would definitely recommend taking the time to do oil like you did–yours should last forever 🙂

And then there’s appliance hardware. Appliance pulls are not just hardware pulls that have a higher price point. It is a more durable hardware that look identical in style to your standard pulls, but are designed for the larger items in your kitchen like refrigerators, dishwashers, pantries, and oversized drawers. They come in a range of sizes from 6” to 36” and are constructed to hold a heavier weight, typically necessitating longer screws and a backplate for installation. The screws can be shortened to the needed size, but its best to follow the instructions and have these pieces installed by a professional to avoid hiccups.
×