The next step was to decide whether to go with pulls, knobs, or a combination of the two– and also the size. THIS WILL SEND YOU TO THE MADHOUSE if you’re not careful. To make my decision easier, I perused my kitchen ideas board on Pinterest and realized the look I was going for was modern and symmetrical– and many of the modern kitchen used only pulls, not knobs. Hmmmm, this was interesting. Maybe it wasn’t so hard to choose?

Thank you so much for helping me understand more about the process to choose new kitchen cabinet hardware. We have been really into rustic looking kitchens lately, and I think that some antique decorative nails could really change the way it looks. Just as you mentioned, you can always change the look of your kitchen again if you do not like the way it looks after a couple of years. Thanks for posting!
For pulls on a flat front cabinet, the bottom corner of the pull should be equidistant from both sides of the cabinet. For Shaker-style cabinets, the same rules apply as with knobs: center the pull on the vertical stile, with the bottom of the pull even with the top of the horizontal stile (or the top even with the bottom of the horizontal stile, for a lower cabinet). These aren’t hard and fast rules—you may want to adjust them depending on what looks best for your cabinets and hardware—but they’re a good place to start.
Cliffside offers a unique brand of stone hardware. The river rock collection is a series of knobs made from river pebbles, which were naturally smoothed by rushing water and by tumbling over each other. They come in shades like gray, salmon-pink, charcoal black, a rusty Martian red and a speckled white that can complement essentially any color scheme imaginable.

Your kitchen is coming along really well, and all that lovely light will be an absolute joy! Sadly, I have just a word of warning about the handles though. We had these in our kitchen, and they proved quite annoying. They’d catch on your clothing, especially blouses/shirts. That end of the front of button-through blouses, where the seam folds back would always get hooked onto the end of the handles! And pockets, too would get caught. This invariably ended up with torn clothing, as you continued to move away, not realising you’d been ‘caught’. We also live near the sea, and ours rusted over a few years, although that may be just an inferior brand. I lived with ours for about 4 years, then changed them all. We had them in our bathrooms, too, and they’ve all been changed as they were such a pain! I can see you love them, so don’t want to burst your bubble, but just thought I’d let you know. :(

Hi Lonnice – I am so happy you found me again. :-) Did you subscribe and then stop getting my posts in your email? I would like to understand what happened if this is the case. Did you need to subscribe again? I did make a few tweaks about 6 months ago to my subscriber list and would like to pinpoint the problem to why you stopped getting the emails in the first place. Thanks for reading :-)
I love your site and your super helpful advice. We’re installing full overlay cabinets in our kitchen and we’re trying to select hinges for the upper cabinets — particularly the cupboard doors on the end which when closed is perpendicular to a wall. Since the door aren’t inset, I’m concerned we won’t be able to open the cupboard a full 90 degrees. Basically, the issue is how to solve the problem of the door swing? Are there any hinges that could solve this problem? I can send elevations if that helps. Thanks so much in advance!
Specializing in hardwood furniture, trim carpentry, cabinets, home improvement and architectural millwork, Wade Shaddy has worked in homebuilding since 1972. Shaddy has also worked as a newspaper reporter and writer, and as a contributing writer for Bicycling Magazine. Shaddy began publishing in various magazines in 1992, and published a novel, “Dark Canyon,” in 2008.
When it comes to designing a kitchen inevitably you have to pick out hardware, and these seemingly small details can literally keep you up at night, going back and forth between brass knobs or stainless steel bars. But thankfully, we’re here to help you get a “handle” on the process. Here are the factors you should consider when choosing kitchen cabinet hardware.
Hanging knobs on a flat-front cabinet is pretty straightforward: You’ll want to position the knob in the bottom corner (for upper cabinets) or top corner (for lower cabinets) of the door. Knobs should be placed equidistant from both sides of the cabinet. A guide like this one can help you to get the measurements right. The exact distance will depend on the look you want and the size of your knobs: Test one or two before you drill a whole kitchen’s worth of holes.
While it is important to stay true to your personal style, you don’t want a lantern that is half the height of your door or an oversized mailbox beside a tiny cottage. So, take into account what you are working with as you choose the style that is most you! “I suggest they get painter’s tape and put it on the house in the dimensions of the fixture to get a sense of the size. You want it to be the correct proportion,” says Brandino Brass team member Megan Brasher, adding, “To get the feel for how it will affect your home’s curb appeal, not only do you need to look at it right next to the front door, but you also need to take a step back and get a view from the street.”

At a home renovation in Connecticut, cabinet fabricator Michael Madore experimented with what he calls an "aggressive" metal-sanding process to pull out the grain from the whitewashed oak plywood. For the hardware-free cabinets, Julie Salles Schaffer looked to a drawer pull detail derived from Giò Ponti’s work—though she admits the radial edging is an effect entirely her own.

Try to establish some sense of visual symmetry. If you are going to mix styles, the secret to having it look great is to counterbalance the mixing and matching with a semblance of symmetry. For instance, make sure all your drawers have the same number and configuration of knobs. Perhaps all drawers of the same size should share the same knob, and smaller drawers can display a different type.

For easy access to below-counter drawers and cabinets with minimal aesthetic impact, hidden pulls can be a great option. They’re usually attached to the top edge of each door and designed as small slivers of metal that jut out of the flush portion. They are designed to be largely concealed by the work surface above, forming a subtle lip that does not deter from the material and design of the cabinetry itself.

I have a solid oak kitchen from the late 1980s. I would like to update the cabinets by painting them but my hinges are exposed. Is it possible to change any exposed hinge to a hidden hinge, or are there some styles that won't be replaceable? Also, has anyone else painted kitchen cabinets with exposed hinges in such a way that it looks good? Thanks!

The style of cabinet hardware you pick will depend a great deal on the style of your kitchen, and also on the kind of cabinets you choose. Traditionally styled cabinets with more intricate face profiles call for traditional hardware: Cabinets with more simply styled or completely flat faces look best with minimal, streamlined knobs and pulls. Some very modern cabinets don’t require hardware at all: Instead, they have grooves on the edges of the door, or open by push latches.


Handles are sold by the center to center measurement(1). Center to center can be spelled out or the universally known “C/C” could be used. Knobs are sold by the diameter(4) of the knob.The measurement could be in inches or millimeters (MM) CabinetParts has both measurements listed for your convenience. (Tip: to convert millimeters to inches use this formula: MM ÷ 25.4)Here is a diagram showing how these are measured:The overall length(2) and the projection(3) are offered when they are available from the manufacturer.Choosing a finish is going to be entirely up to you. Maybe your cabinets need a satin nickel look for a more modern look or maybe you are in the mood for flat black finished hardware for a more southwestern feel, or maybe weathered copper is your fancy. There are many, many choices for finish to make your kitchen look like a million bucks.The type of handle or knob will depend on what you like or maybe the motif of the rest of the room or house. There are modern, eclectic, or traditional looks and more.Most collections will have a pull and a knob that “match” so you can have the same finish throughout the room. You do not always have to choose pieces from the same collection, just remember to always choose the finish from the same manufacturer. Even though different manufacturers may have finishes that have the same name, they will often vary in the color and shade.These choices will be among the most important of the entire project. A knob and pull will put the finishing touch on the project and be one of the first things people will notice.Sometimes the hardware is noticed before the color or type of cabinet or door.Here is a listing of all of the manufacturers CabinetParts.com offers: Top Konbs, Amerock, Schaub and Co, Atlas Homewares, Notting Hill, Berenson, Jeffrey Alexander, Century Hardware, Hickory Hardware, Laurey Hardware, Liberty Hardware, Elements, Stone Mill Hardware, Hafele, R. Christensen, MNG Hardware, Acorn Mfg.Some of the companies listed above also offer Bath Hardware and Decorative Home Accents that may help complete a project.
Contemporary kitchens have sleek lines, very little ornamentation and minimalistic colors. So, for a contemporary style kitchen, it is wise to choose hardware that is simple and streamlined. Linear bar handles with straight lines or curved barrel handles are the perfect choice. Since stainless steel appliances are a hallmark of a contemporary kitchen, you can also select handles for your cabinetry in a similar style and finish as your appliance handles. 
Furthermore, hardware attracts the eye like a bright light. Functionality aside, it is the ultimate accent piece — it provides a pop to cabinets and drawers that can make or break the décor of a room. It also keeps the wood of our cabinets and drawers looking fresh by taking the brunt of the natural oils in our hands, which we leave behind every time we reach for the cabinet to grab something.
My home was built in 1940 and the kitchen cabinet hinges and pulls are the hammered black ones. I want to replace same pulls with chrome or polished chrome but cannot find the offset hinges or pulls to fit the holes. I really do not want to have to fill the holes to get another kind. Where can I find these? Have seen them in the past but now I cannot find them. Where should I look?
I did a little google search to see what color my oven (and sink and cooktop and bathroom) used to be. It was called Mexican sand. I also once had olive green washer, dryer, freezer and refrigerator. Oh my, we thought we were really stylin’ back in the good old 70’s. I cringe when I see a photo of myself in the fashion of the day too. I miss my youthful look, but not the styles.
It’s easy to get caught up in selecting the larger items, such as cabinetry, countertops or flooring for your new kitchen when building a custom home or renovating your existing home. "A project isn't complete until you've selected the right hardware that strikes a personal balance between form and function. These final touches will pull the whole project together and are fantastic for imbuing it with a flair that reflects your personality," says Jonathan Pilley, Co-Owner at Push Pull Decorative Hardware in North Bethesda, Maryland. Decorative hardware comes in a variety of types, sizes, styles, materials and finishes. So, what should you pick? Read our 5 tips on choosing the right kitchen cabinet hardware.
Knobs are installed with a single screw through one focused entry point on a door or drawer. Pulls are installed with two screws through two points of contact on a door or drawer. Before any holes are drilled, make sure you give detailed instructions to your homebuilder or remodeling professional so that they know the correct type of handle to install on each cabinet door or drawer. You will also need to specify the position of the knob or pull so that they are installed in a consistent manner throughout the kitchen.
Okay, I haven’t even finished reading this post, but I just have to comment. First of all, I think you are awesome. I have been wanting all kinds of things done to my house, and my husband is pretty capable, but very busy, and far less interested in house things than I am. I just look at the things you do, and I think how I can certainly learn to tackle more of the things that I want to. Second, a post like this is so helpful. I know it takes time to write and I just appreciate the education so much. So, thank you so much for being awesome, and also giving awesome-ness lessons… 🙂

Caring for decorative hardware purchased from Cliffside Industries is easy. Use only a soft cloth dampened with water for cleaning. The most important thing to remember is never to apply any chemicals or abrasive cleaners, including all kinds of soap or detergent. Using these products damages the protective lacquer and may change the appearance of the piece. Any use of chemicals, abrasives or soaps will void your warranty.

These small items — doorknobs, drawer pulls, cabinet-door handles — are "the jewelry" that can add style and sparkle to any space, says New York-based interior designer Young Huh. Just as the right necklace can turn a simple dress into a fashion statement, a striking new set of knobs on an old cabinet, or vintage crystal doorknobs can bring a huge dose of style to your home with minimal expense, she says.
Wine Logic wine racks are built-in right underneath your kitchen cabinets, eliminating the need to take up any counter space with a freestanding wine rack. Wine Logic racks come with two to five separate slide out trays that each hold up to six bottles of wine. And the best part is, Wine Logic’s horizontal design stores wine in the best possible condition, keeping the corks wet and the wine untouched by air.
These small items — doorknobs, drawer pulls, cabinet-door handles — are "the jewelry" that can add style and sparkle to any space, says New York-based interior designer Young Huh. Just as the right necklace can turn a simple dress into a fashion statement, a striking new set of knobs on an old cabinet, or vintage crystal doorknobs can bring a huge dose of style to your home with minimal expense, she says.
Kitchen renovation is one of the important part of your kitchen. But for this first you should make a plan, after that decide the budget. There are variety of flooring materials and from this you should select one according to your needs and preferences. Then select the kitchen cabinet hardware. For this you should decide which design you want to select, then select the size and shape of the material. In your blog you give the clear idea on how to select the kitchen cabinet hardware. You can refer this: https://kitchenemp.net/kitchens/
The homeowner has already installed a new tile backsplash, and will also be replacing the floors with new tile and painting the walls once I’m finished with the cabinets.  But the homeowner was concerned about the hinges standing out against a light cabinet color.  A cabinet refresh is going to help tie the updates together, and when we got to talking about the hinges, I did some research, and found a great local woodworker to help change the hinges from exposed to concealed.
Good morning and happy Monday, lovely people! I hope y’all had a wonderful Thanksgiving week. Ours was a little on the insane side, but it ended perfectly. We moved to our new house {Memaw’s house} a little over a week ago. It was crazy getting settled just in time to host our family’s Thanksgiving dinner. It was hard without Memaw. Tears came easily and our family time was just really sweet. I’m very thankful.
What kind of new hardware should you install in your updated kitchen? There are so many choices out there it can be overwhelming. Knobs or Pulls? Nickel or Brass? Will you be able to see the holes from the old hardware? Because I am being asked these questions on a daily basis I’ve put together a general guide to updating hardware and have included some of my favorites to share with you.
×