Choosing your kitchen hardware is a great way to customize the look of your cabinetry and drawers. From pulls to knobs and handles, you can get your kitchen cabinet hardware in almost any shape you desire. Choosing the right shape mainly depends on personal preference. I once had handles that we’re a bit snug on my finger when I opened a cabinet. As a result, every time I shut a cabinet, the hardware would tug my finger. After a short time, enough was enough and I switched out my handles for knobs with no further issues. You’d never imagine a small detail such as cabinet hardware type would cause so much frustration, but it truly does make a difference.

2. Keep finishes cohesive. You’ll find hardware in a range of finishes from brushed nickel to brass. While mixing and matching the hardware around your kitchen is fine, you should try to maintain the same finish and keep colors as close as possible. Sometimes you’re forced to buy hardware from more than one retailer, but when doing so make sure you keep finishes cohesive.
Consult with a contractor or a knowledgeable salesperson about which hinges will work with your doors. If your doors are flush with the cabinets, butt hinges can be used. They are lower in price than others but do not self-close. European hinges are installed on full overlay, frameless or inset doors. They are widely used because of their ease of installation and ability to be adjusted once in place. These hinges self-close. Partial wraparound hardware will support larger doors, but it does not self-close. Several other types hinges are available. The construction of your door, ease of installation and price will need to be considered. .
The cons are a few: 1. MDF is heavy in relation to wood or plywood. 2. MDF does not accept screws very well. You must use coarse thread screws and always pre-drill. Apply the hinge screws by using a hand-held screwdriver instead of a screw gun. If you don't, they can strip the hole quickly. 3. Over time the screws will come lose just from opening and closing the doors (just go around every so often and tighten the screws). 4. If water gets into the doors, they will swell and they will need to be replaced so seal them well.

Shake a can of rust-inhibiting metal spray primer for the amount of time recommended by the manufacturer. Position the can the recommended distance away from the hinges -- it varies among manufacturers. Spray a light coat of primer on the hinges and screw heads using steady, even sweeps. Make sure you spray the sides and edges. Shake the can frequently while you spray. Allow the primer to dry for the amount of time recommended by the manufacturer. Apply a second coat of primer and allow it to dry completely.
The cons are a few: 1. MDF is heavy in relation to wood or plywood. 2. MDF does not accept screws very well. You must use coarse thread screws and always pre-drill. Apply the hinge screws by using a hand-held screwdriver instead of a screw gun. If you don't, they can strip the hole quickly. 3. Over time the screws will come lose just from opening and closing the doors (just go around every so often and tighten the screws). 4. If water gets into the doors, they will swell and they will need to be replaced so seal them well.
Rest easy, friends, you can do this, too.  And then, since it looks much better and you are thrilled and at peace with it, you can move on to dreaming about that full kitchen reno you are still working towards… one day.  Or, maybe you will be so happy with the small changes you made that you can cross that idea right off the list and move on to dreaming about making other areas of your home just right.
Some styles of kitchen cabinets are designed to open at the side of the door, so they don’t have outer knobs. When re-facing cupboard doors as part of a remodeling project, new knobs can still be added to these self-opening styles. Consider adding knobs or handles that create visual interest. Careful planning is needed as holes will need to be drilled in the cabinet doors to add the new knobs.
It’s definitely possible to change out the hinges without redoing the cabinets – you would just have to make sure that the holes on the frames where the old hinges were, are able to be filled and touched up so that they’re not obvious. I’m not sure of the cost, but hinges aren’t cheap, and I definitely recommend using a carpenter to do the work. Hinges can be maddening!
Shake a can of rust-inhibiting metal spray primer for the amount of time recommended by the manufacturer. Position the can the recommended distance away from the hinges -- it varies among manufacturers. Spray a light coat of primer on the hinges and screw heads using steady, even sweeps. Make sure you spray the sides and edges. Shake the can frequently while you spray. Allow the primer to dry for the amount of time recommended by the manufacturer. Apply a second coat of primer and allow it to dry completely.
You may also have seen cabinets that are so modern and minimalist that they have no knobs or pulls whatsoever—and they look like they’re impossible to open! The trick is, in fact, a mechanism with a spring located on the inside of the cabinet. When you push on the corner of a cabinet, you compress and then release the spring, which in turn pops the cabinet open. In order to close the cabinet, you simply push it closed until you hear the little "click" that means the spring is back in its locked position.
Cliffside is one company that works exclusively with high-quality producers who make sturdy, kiln-fired glass. This glass comes in many different colors to suit your palette, as well as different shapes and sizes. Because the glass is strong, it can stand up to the rigors of dropped kitchen items, quick yanks and more. This durability also means it can be used for more than just knobs — there are glass handles available as well.
Our drawer pulls come in a nearly endless variety of materials, styles and finishes. For a contemporary, modern look, try a brushed nickel or chrome drawer pull. If you’re considering a more traditional, classic style, check out our bronze, brass, pewter and black drawer pulls. You’ll be amazed by how a small detail like cabinet hardware can change the look of an entire room. Updating kitchen cabinet hardware, or furniture hardware is also a quick and easy exercise that requires few tools, minimal effort, and is relatively inexpensive.
I'm glad that you talk about the different hardware options, such as how you can choose something more decorative or if you are more focused on the functionality you want pulls and knobs that are subtle, like silver or clear colored. Knowing what you want would be useful so you can then easily search the various door hardware options online. If you search online, it could help you get more options and you could find stores that focus more on the type of knobs, pulls, and anything else that you're looking for.

When choosing a backsplash color scheme, keep in mind the type of look you want for your kitchen. By choosing a backsplash color that blends in with your wall color, you’ll be creating a streamlined, coordinated look. If you want to make a statement and have your backsplash pop, try choosing one or even a few colors that accent your wall color, making it stand out from the background.


Below and above the sink can be two different color schemes. Don’t worry, you can mix and match more than you might think and still obey the laws of symmetry. It can provide a sunny, uplifting splash to have a lighter color above the level of the countertops, such as a warm brass or gold. Particularly with items like faucets and sconces, a lighter color around eye level will create a happy glow.
Your kitchen is looking beautiful. White paint is a miracle worker…so are you. I have an old 1970’s GE oven that looks just like yours. It’s a great oven and still works perfectly. I had the door, which was originally light brown, re-enameled years ago when I painted my kitchen white. It’s held up beautifully. I just wish I had two ovens like yours. Sure would come in handy for holiday cooking.

The other option for changing kitchen cabinet knobs is to purchase new ones. The two main types of cabinet fixtures for kitchens are circular pulls and metal bars. The round pulls tend to be old-fashioned, while the metal bar handles are often more contemporary. Cabinet pulls can be made more modern by painting them metallic silver. Metal bar cabinet door handles are usually silver-colored and narrow; this style is often seen with darker wood toned cabinets.


Hello Mr. TretheweyMy name is terry cotto, when we built our beautiful home 16 years ago, in Sierra Madre Ca I had my claw tub installed,( my child hood remembrance) It appears, that the claw legs of the tub were not installed properly, and one leg fell off , tub was slightly tipping to the right. I had a handyman come over and reinstall the claw legs, tighten so this would not happen again. The other day, while I was bathing I noticed the seal of the drain on the outside rubber was not laying properly, plus it was leaking, ( I think this was due to the leg falling off and unbalancing the ring. Well, now I really don't know what to do about that. I believe the thing to do is remove the cover off the top drain , ok, but than what do I have to move the claw tub, impossible. How do I replace the rubber of the outside of the top drain pipe, it appears to be brittle. (Not good)Please answer my questions, and I will hire the handy man again to help me. Thank you. I have learned so much from T.O.H weekly shows, I am a loyal fan at 75. I tell my 80 year old husband, you need to watch these shows with me, and we can do it ourselves, the right way. God Bless you all for the great job your doing, I need to know how to do it right, so it doesn't happen again. a picture would be good, I can see exactly how its done?
Hidden hinges also come in a soft-close style if you’re one of those people who want the latest and greatest. (Is it really that bad to hear a door close?) My new cabinets came with soft close hinges that I personally could take or leave.  I still find myself trying to shut them all the way instead of letting them do their thing. You might not want soft-close hinges if you’re the type who likes to slam things when irritated. (Just a thought.)
Go to the home improvement center and get a 35mm Concealo Hinge mounting kit, it comes with a forstner bit (invented by Benjamin Forstner, in case you didn’t know) and a jig for marking the drill location. You’ll also want to make sure you get 35mm European-style hinges too, but before you buy them you’ll need to determine if you have ½” overlay or full overlay doors. ½” overlay doors overlap the face frames by a ½”, full overlay doors fully overlap the face frame leaving about an 1/8” showing on the outside edge. My doors were all ½” overlay, so I bought eighty 3-way adjustable hinges from eBay. I’m not sure what I was thinking because I ended up with a LOT of hinges left over. Warm up your drill and let’s move on to the next step.

Thanks Mary. That is a good question. There is another similar product from DecoArt called Metallic Lustre but I am not sure if it is available in Europe either. (Also, I haven’t used it so I can’t say for sure if I would recommend it.) Also, it isn’t exactly the same but silver spray paint can also work. After cleaning the hinges, spray them with spray primer and then follow up with a spray paint in the metallic finish you want.
While it is important to stay true to your personal style, you don’t want a lantern that is half the height of your door or an oversized mailbox beside a tiny cottage. So, take into account what you are working with as you choose the style that is most you! “I suggest they get painter’s tape and put it on the house in the dimensions of the fixture to get a sense of the size. You want it to be the correct proportion,” says Brandino Brass team member Megan Brasher, adding, “To get the feel for how it will affect your home’s curb appeal, not only do you need to look at it right next to the front door, but you also need to take a step back and get a view from the street.”
That being said, buying every make and model turned out to be a good idea. I was pretty pumped when I installed my first door…until I shut the door and there was a gap the size of Kansas where the door didn’t cover my opening. I should have taken a picture because it was pretty hilarious-looking. Wrong hinge. So I removed the 1 1/4″ overlay hinge, installed the 1/2″ overlay and was good to go. The holes that need to be drilled in the door will be the same in size, depth and location regardless of your overlay measurement.
I'm glad that you talk about the different hardware options, such as how you can choose something more decorative or if you are more focused on the functionality you want pulls and knobs that are subtle, like silver or clear colored. Knowing what you want would be useful so you can then easily search the various door hardware options online. If you search online, it could help you get more options and you could find stores that focus more on the type of knobs, pulls, and anything else that you're looking for.
Whereas crystal is made primarily of silica and lead oxide, glass is largely composed of silica and soda lime. The lime is the reason glass can have a greenish tint when light is shining through it, whereas crystal is clear. Glass can provide the perfect accent to a room, and is an excellent secret weapon if you are wondering how to add a “pop” without overdoing it.
Cup pulls add a unique style to drawers by going beyond the basic drawer handle. Whether you’re looking for a way to add antique or rustic style to your kitchen or you want to add modern flair, cup pulls enhance any décor. Since cabinet pulls are used frequently each day, look for quality metal styles that are durable and built to last. Cup pulls also come in interesting shapes and designs like leaves and clamshells to give your kitchen a fun aesthetic.
The choice between cabinet pulls and knobs isn’t easy — both come with positives and negatives. Keep in mind that you’ll be using your knobs or pulls every day. Whatever you choose should feel natural in your hand and flow with the décor of the room. You should consider your kitchen’s décor and style, the look you want to achieve, your budget, ease of cleaning, ease of use, the weight of your drawers and more.
Modern cabinet door hinges are a critical part to any cabinet, and are also quite complex; there are about a dozen (if not more) different types of hinges, depending on whether you have face-frame cabinets or frameless cabinets. Face-frame cabinets include a frame made of 1-½" to 2" wide solid wood that attaches to the front edges of the cabinets. This type of cabinet construction is common in American-made cabinets, and hinges will then mount directly to this frame. However, if you have frameless cabinets—which are typically made in Europe, like IKEA cabinets—your cabinets are basically just a four-sided box with no frame around the front edges. In this case, the hinges will mount directly to the interior of the cabinet. 

Hi Diane….Glad to see you again and happy to see the progress on your lake home. I was a subscriber and then suddenly lost you about the time you started working on your staircase! I was afraid it had driven you away from your blog!! You showed up on another blog yesterday and now I plan to catch up on all I have missed. Thank you for accepting me again!!

×